A problem occurred when there was one SGWU/UPF and multiple SGWC/SMF.
When SGWU and UPF create a session, if the SEID is the same,
the existing session information is used without creating an additional session.
These problems were solved by using the F-SEID including IP information
in the process of checking the existing session.
In the past only GTPv2C was supported, and had the "gtp" generic prefix.
Later on, GTPv1C support was added, and "gtp1" prefix was used.
Let's move GTPv2C specific bits to have "gtp2" prefix too, and leave
"gtp" prefix for generic stuff among different GTP versions.
All process will be forcely exited if it failed to encode the S1AP/NGAP/GTP/PFCP message. It is to make sure there was no problem with the encoding of open5gs.
* Flow-Description use 'to assigned' in Gx Interface
* Support SDF Filter ID
* Support F-TEID's Choose
* BAR(Buffering) is added in PFCP session
* Default Apply Action uses NOCP|BUFF
So far, no operation was performed when Error Indication was received
from eNodeB. For that reason, I solved #568 issues by controlling
the MME to prevent this from happening.
Now, when GTP-U Error Indication is received, MME and SGW are implemented
to do what they have to do. I hope that the network can be restored
by responding appropriately even if Error Indication occurs.
<DOWNLINK>
RX : permit out from <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT> to <UE_IP> <UE_PORT>
GX : permit out from <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT> to <UE_IP> <UE_PORT>
PFCP : permit out from <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT> to <UE_IP> <UE_PORT>
RULE : Source <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT> Destination <UE_IP> <UE_PORT>
TFT : Local <UE_IP> <UE_PORT> REMOTE <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT>
<UPLINK>
RX : permit in from <UE_IP> <UE_PORT> to <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT>
GX : permit out from <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT> to <UE_IP> <UE_PORT>
PFCP : permit out from <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT> to <UE_IP> <UE_PORT>
RULE : Source <UE_IP> <UE_PORT> Destination <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT>
TFT : Local <UE_IP> <UE_PORT> REMOTE <P-CSCF_RTP_IP> <P-CSCF_RTP_PORT>
- Set the number of UEs in units of AMF/MME instead of gNB/eNB.
- See default value as shown below
Number of UEs per AMF/MME : 4,096
Number of gNB/eNB per AMF/MME : 32
Sukchan Lee
Pau Espin