The use of the Gy interface (SMF acting as CTF towards an OCS node) is
mandated through configuration file. Default value "enable: auto" will
only make use of it in case a Diameter peer announcing support for the
Credit-Control Application is found.
Upon subscriber session creation, and after auth check over Gx, the SMF
will create a Gy session with the OCS and only after that step the SMF
will accept the session back to the subscriber.
The OCS may then grant some traffic volumes/time and ask to be notified
back with updated measurements.
In order to get the measurements, the SMF relies on PFCP URR configured
to the UPF through Session Repoort Request messages.
When closing the subscriber session, the SMF will also terminate the Gy
session at the OCS.
So far only some specifics parts of the Gy interface as well as the PFCP
side are implemented. Those should be enough to at least have
volume/time thresholds granted by the OCS, which then will be able to
track subsriber resource use.
This patch doesn't implement the OCS side of the Gy interface, that's
left as a future exercise. The interface was tested using an OCS
emulator implemented in TTCN-3 [1]
[1] https://cgit.osmocom.org/osmo-ttcn3-hacks/
TODO:
* Use an event for the report, like SMF_EVT_N4_TIMER?
* Properly set Service identifier in Gy CCR
* SMF: Properly set pkt/octet volumes in Gy CCR
** Update when receiving PFCP Modify Response.
* Figure out best way to require Gy through config file in open5gs-smfd.
* Create a new sess-sm.c which handles smf_sess_t state through
Gx+Gy+PFCP creation, modification and tear down. This way we can do
stuff in parallel, for instance Gx+Gy. It will alsoavoid duplicating
some code paths due to Gy being optional.
All process will be forcely exited if it failed to encode the S1AP/NGAP/GTP/PFCP message. It is to make sure there was no problem with the encoding of open5gs.
* Flow-Description use 'to assigned' in Gx Interface
* Support SDF Filter ID
* Support F-TEID's Choose
* BAR(Buffering) is added in PFCP session
* Default Apply Action uses NOCP|BUFF
- Set the number of UEs in units of AMF/MME instead of gNB/eNB.
- See default value as shown below
Number of UEs per AMF/MME : 4,096
Number of gNB/eNB per AMF/MME : 32
Sukchan Lee
Pau Espin