These have been promoted out of staging so hopefully they're really
portable now.
Keep them disabled on armel/{ixp4xx,orion5x} due to size constraints.
svn path=/dists/trunk/linux/; revision=21127
1. Reset or remove values for config symbols that were only
configurable if EXPERT.
2. Set additional configurable symbols to their default values.
This should have no effect on the actual configuration, except for
sh4 where EXPERT is *always* set and so the settings in 1 were
still being followed.
svn path=/dists/trunk/linux/; revision=20825
Leave it enabled for armel/{iop32x,ixp4xx,kirkwood,orion5x} and m68k.
Drop the workaround patch for powerpc.
svn path=/dists/sid/linux/; revision=20732
These symbols were either (1) removed entirely or (2) merged or
renamed, and we already configure the other symbol.
svn path=/dists/trunk/linux/; revision=20604
All that config cleanup has brought them back under the size limit again
... for now ... with gcc-4.7. (I don't have a gcc-4.8 cross-compiler
to check with.)
svn path=/dists/trunk/linux/; revision=20588
No Alpha, PA-RISC or SH4 system supports PCI Express.
The older Marvell SoCs supported by iop32x and ixp4xx don't, but the
newer SoCs do. ARM Versatile doesn't support it and I'm pretty sure
QEMU won't let you add it, but will leave versatile alone for now.
Most supported MIPS platforms don't, but Octeon does.
I don't think PowerPC SPE systems have either PCI or PCI Express, but
I won't touch that configuration now.
svn path=/dists/trunk/linux/; revision=20579
Disable most platform drivers, SPI and I2C drivers at the top level.
Platform drivers should be selected by architecture and flavour
configurations, and generally are. SPI and I2C devices aren't easily
detectable and their drivers aren't auto-loaded, so again they should
usually be selected in specific configuration files and probed
according to board code or FDTs.
As exceptions, I2C hwmon devices may be probed by lm-sensors and many
media tuners include I2C devices which are probed with the help of the
higher-level device driver. I've tried to be conservative and also
left I2C iio, input, leds and misc devices alone for now.
Disable the regulator subsystem at the top level as only some
architectures will need it.
Disable MTD_NAND_PLATFORM, PDA_POWER and FB_S1D13XXX on x86, as these
don't appear likely to be used on any x86 system that could run our
generic kernel images.
svn path=/dists/trunk/linux/; revision=20556
USB_EHCI_ROOT_HUB_TT adds about 10 lines of code and is safe even if
not needed, so it's never worth turning off.
USB_EHCI_TT_NEWSCHED was 'new' in 2006 and is now the default, so
hardly anyone will be testing the 'old' code now.
svn path=/dists/trunk/linux/; revision=20546
Drop most patches as they're already upstream in 3.8 or early.
Refresh some others for 3.8. In particular, remove use of __devinit from
debian/radeon-firmware-is-required-for-drm-and-kms-on-r600-onward.patch
as this macro is no longer defined or needed.
svn path=/dists/trunk/linux/; revision=19856
Since Linux 2.6.29, this subsystem would crash if anyone tried to use
it, but no-one noticed. It will be removed upstream in Linux 3.9.
svn path=/dists/trunk/linux/; revision=19835
A change in Linux 2.6.29 completely broke it (it would oops on load)
but no-one reported this, therefore it has no users. It was removed
upstream and will clearly not be supportable in Debian.
svn path=/dists/sid/linux/; revision=19787
Ben Hutchings
Ian Campbell
Bastian Blank
Arnaud Patard
Nobuhiro Iwamatsu