- Various ancient SCSI drivers were removed; delete config for them
- r8723au was replaced by rtl8xxxu; enable the latter instead and for
all architectures
- netfilter config symbols were renamed; enable the new ones
- Various other config symbols are obsolete; delete them
- Various other config symbols moved to different Kconfig files
1. Reset or remove values for config symbols that were only
configurable if EXPERT.
2. Set additional configurable symbols to their default values.
This should have no effect on the actual configuration, except for
sh4 where EXPERT is *always* set and so the settings in 1 were
still being followed.
svn path=/dists/trunk/linux/; revision=20825
Apparently no m68k platform has configurable HZ, cpufreq or system
power management support. The corresponding Kconfig files are not
included from arch/m68k/Kconfig, and there is no point in setting
their symbols.
svn path=/dists/trunk/linux/; revision=20605
Disable most platform drivers, SPI and I2C drivers at the top level.
Platform drivers should be selected by architecture and flavour
configurations, and generally are. SPI and I2C devices aren't easily
detectable and their drivers aren't auto-loaded, so again they should
usually be selected in specific configuration files and probed
according to board code or FDTs.
As exceptions, I2C hwmon devices may be probed by lm-sensors and many
media tuners include I2C devices which are probed with the help of the
higher-level device driver. I've tried to be conservative and also
left I2C iio, input, leds and misc devices alone for now.
Disable the regulator subsystem at the top level as only some
architectures will need it.
Disable MTD_NAND_PLATFORM, PDA_POWER and FB_S1D13XXX on x86, as these
don't appear likely to be used on any x86 system that could run our
generic kernel images.
svn path=/dists/trunk/linux/; revision=20556
From: Thorsten Glaser <tg@mirbsd.de>
- disable some functionality due to size constraints
- switch to using initrd
- drop all flavours; build a generic image that runs on
multiple subarchitectores (old Amiga, Atari, Macintosh tested;
old BVME6000, MVME147, MVME16x, new Apollo, Q40/Q60 untested)
- use gcc-4.8
- add patch to make Atari EtherNAT actually selectable
svn path=/dists/sid/linux/; revision=20413
Since Linux 2.6.29, this subsystem would crash if anyone tried to use
it, but no-one noticed. It will be removed upstream in Linux 3.9.
svn path=/dists/trunk/linux/; revision=19835
All Atheros wireless drivers depend on a new symbol ATH_CARDS.
Two comedi drivers were merged into others and no longer have their
own config symbols.
drivers/staging/telephony has been removed.
svn path=/dists/trunk/linux/; revision=19832