* Fix flash parameters passed to Linux for PPChameleon board
* Remove eth_init() from lib_arm/board.c; it's done in net.net.c.
This commit is contained in:
wdenk
parent
f832d8a143
commit
46a414dc12
|
|
@ -2,6 +2,10 @@
|
|||
Changes since U-Boot 1.1.1:
|
||||
======================================================================
|
||||
|
||||
* Fix flash parameters passed to Linux for PPChameleon board
|
||||
|
||||
* Remove eth_init() from lib_arm/board.c; it's done in net.net.c.
|
||||
|
||||
* Patch by Paul Ruhland, 10 Jun 2004:
|
||||
fix support for Logic SDK-LH7A404 board and clean up the
|
||||
LH7A404 register macros.
|
||||
|
|
|
|||
|
|
@ -96,11 +96,15 @@ int misc_init_f (void)
|
|||
return 0; /* dummy implementation */
|
||||
}
|
||||
|
||||
extern flash_info_t flash_info[]; /* info for FLASH chips */
|
||||
|
||||
int misc_init_r (void)
|
||||
{
|
||||
#if 0 /* test-only */
|
||||
DECLARE_GLOBAL_DATA_PTR;
|
||||
|
||||
/* adjust flash start and size as well as the offset */
|
||||
gd->bd->bi_flashstart = 0 - flash_info[0].size;
|
||||
gd->bd->bi_flashoffset= flash_info[0].size - CFG_MONITOR_LEN;
|
||||
#if 0
|
||||
volatile unsigned short *fpga_mode =
|
||||
(unsigned short *)((ulong)CFG_FPGA_BASE_ADDR + CFG_FPGA_CTRL);
|
||||
|
|
@ -192,8 +196,6 @@ int misc_init_r (void)
|
|||
*duart0_mcr = 0x08;
|
||||
*duart1_mcr = 0x08;
|
||||
#endif
|
||||
#endif
|
||||
|
||||
return (0);
|
||||
}
|
||||
|
||||
|
|
|
|||
|
|
@ -44,10 +44,10 @@ unsigned long flash_init (void)
|
|||
#ifdef __DEBUG_START_FROM_SRAM__
|
||||
return CFG_DUMMY_FLASH_SIZE;
|
||||
#else
|
||||
unsigned long size_b0;
|
||||
unsigned long size;
|
||||
int i;
|
||||
uint pbcr;
|
||||
unsigned long base_b0;
|
||||
unsigned long base;
|
||||
int size_val = 0;
|
||||
|
||||
/* Init: no FLASHes known */
|
||||
|
|
@ -57,22 +57,22 @@ unsigned long flash_init (void)
|
|||
|
||||
/* Static FLASH Bank configuration here - FIXME XXX */
|
||||
|
||||
size_b0 = flash_get_size((vu_long *)FLASH_BASE0_PRELIM, &flash_info[0]);
|
||||
size = flash_get_size((vu_long *)FLASH_BASE0_PRELIM, &flash_info[0]);
|
||||
|
||||
if (flash_info[0].flash_id == FLASH_UNKNOWN) {
|
||||
printf ("## Unknown FLASH on Bank 0 - Size = 0x%08lx = %ld MB\n",
|
||||
size_b0, size_b0<<20);
|
||||
size, size<<20);
|
||||
}
|
||||
|
||||
/* Setup offsets */
|
||||
flash_get_offsets (-size_b0, &flash_info[0]);
|
||||
flash_get_offsets (-size, &flash_info[0]);
|
||||
|
||||
/* Re-do sizing to get full correct info */
|
||||
mtdcr(ebccfga, pb0cr);
|
||||
pbcr = mfdcr(ebccfgd);
|
||||
mtdcr(ebccfga, pb0cr);
|
||||
base_b0 = -size_b0;
|
||||
switch (size_b0) {
|
||||
base = -size;
|
||||
switch (size) {
|
||||
case 1 << 20:
|
||||
size_val = 0;
|
||||
break;
|
||||
|
|
@ -89,7 +89,7 @@ unsigned long flash_init (void)
|
|||
size_val = 4;
|
||||
break;
|
||||
}
|
||||
pbcr = (pbcr & 0x0001ffff) | base_b0 | (size_val << 17);
|
||||
pbcr = (pbcr & 0x0001ffff) | base | (size_val << 17);
|
||||
mtdcr(ebccfgd, pbcr);
|
||||
|
||||
/* Monitor protection ON by default */
|
||||
|
|
@ -98,8 +98,8 @@ unsigned long flash_init (void)
|
|||
0xffffffff,
|
||||
&flash_info[0]);
|
||||
|
||||
flash_info[0].size = size_b0;
|
||||
flash_info[0].size = size;
|
||||
|
||||
return (size_b0);
|
||||
return (size);
|
||||
#endif
|
||||
}
|
||||
|
|
|
|||
|
|
@ -414,6 +414,7 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis)
|
|||
|
||||
out32 (EMAC_IAL + hw_p->hw_addr, reg);
|
||||
switch (devnum) {
|
||||
#if defined(CONFIG_NET_MULTI)
|
||||
case 1:
|
||||
/* setup MAL tx & rx channel pointers */
|
||||
/* For 405EP, the EMAC1 tx channel 0 is MAL tx channel 2 */
|
||||
|
|
@ -422,6 +423,7 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis)
|
|||
/* set RX buffer size */
|
||||
mtdcr (malrcbs1, ENET_MAX_MTU_ALIGNED / 16);
|
||||
break;
|
||||
#endif
|
||||
case 0:
|
||||
default:
|
||||
/* setup MAL tx & rx channel pointers */
|
||||
|
|
|
|||
|
|
@ -121,11 +121,7 @@
|
|||
*/
|
||||
#define CFG_SDRAM_BASE 0x00000000
|
||||
#define CFG_FLASH_BASE 0x40000000
|
||||
#ifdef DEBUG
|
||||
#define CFG_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */
|
||||
#else
|
||||
#define CFG_MONITOR_LEN (128 << 10) /* Reserve 128 kB for Monitor */
|
||||
#endif
|
||||
#define CFG_MONITOR_BASE CFG_FLASH_BASE
|
||||
#define CFG_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */
|
||||
|
||||
|
|
@ -135,11 +131,12 @@
|
|||
* the maximum mapped by the Linux kernel during initialization.
|
||||
*/
|
||||
#define CFG_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux */
|
||||
|
||||
/*-----------------------------------------------------------------------
|
||||
* FLASH organization
|
||||
*/
|
||||
#define CFG_MAX_FLASH_BANKS 2 /* max number of memory banks */
|
||||
#define CFG_MAX_FLASH_SECT 67 /* max number of sectors on one chip */
|
||||
#define CFG_MAX_FLASH_SECT 71 /* max number of sectors on one chip */
|
||||
|
||||
#define CFG_FLASH_ERASE_TOUT 120000 /* Timeout for Flash Erase (in ms) */
|
||||
#define CFG_FLASH_WRITE_TOUT 500 /* Timeout for Flash Write (in ms) */
|
||||
|
|
@ -148,6 +145,10 @@
|
|||
#define CFG_ENV_OFFSET 0x8000 /* Offset of Environment Sector */
|
||||
#define CFG_ENV_SIZE 0x4000 /* Total Size of Environment Sector */
|
||||
|
||||
/* Address and size of Redundant Environment Sector */
|
||||
#define CFG_ENV_OFFSET_REDUND (CFG_ENV_OFFSET+CFG_ENV_SIZE)
|
||||
#define CFG_ENV_SIZE_REDUND (CFG_ENV_SIZE)
|
||||
|
||||
/*-----------------------------------------------------------------------
|
||||
* Hardware Information Block
|
||||
*/
|
||||
|
|
@ -260,9 +261,11 @@
|
|||
#define CFG_REMAP_OR_AM 0x80000000 /* OR addr mask */
|
||||
#define CFG_PRELIM_OR_AM 0xE0000000 /* OR addr mask */
|
||||
|
||||
/* FLASH timing: ACS = 11, TRLX = 0, CSNT = 1, SCY = 5, EHTR = 1 */
|
||||
#define CFG_OR_TIMING_FLASH (OR_CSNT_SAM | OR_ACS_DIV2 | OR_BI | \
|
||||
OR_SCY_5_CLK | OR_EHTR)
|
||||
/*
|
||||
* FLASH timing:
|
||||
*/
|
||||
#define CFG_OR_TIMING_FLASH (OR_ACS_DIV1 | OR_TRLX | OR_CSNT_SAM | \
|
||||
OR_SCY_3_CLK | OR_EHTR | OR_BI)
|
||||
|
||||
#define CFG_OR0_REMAP (CFG_REMAP_OR_AM | CFG_OR_TIMING_FLASH)
|
||||
#define CFG_OR0_PRELIM (CFG_PRELIM_OR_AM | CFG_OR_TIMING_FLASH)
|
||||
|
|
@ -291,12 +294,42 @@
|
|||
|
||||
/*
|
||||
* Memory Periodic Timer Prescaler
|
||||
*
|
||||
* The Divider for PTA (refresh timer) configuration is based on an
|
||||
* example SDRAM configuration (64 MBit, one bank). The adjustment to
|
||||
* the number of chip selects (NCS) and the actually needed refresh
|
||||
* rate is done by setting MPTPR.
|
||||
*
|
||||
* PTA is calculated from
|
||||
* PTA = (gclk * Trefresh) / ((2 ^ (2 * DFBRG)) * PTP * NCS)
|
||||
*
|
||||
* gclk CPU clock (not bus clock!)
|
||||
* Trefresh Refresh cycle * 4 (four word bursts used)
|
||||
*
|
||||
* 4096 Rows from SDRAM example configuration
|
||||
* 1000 factor s -> ms
|
||||
* 32 PTP (pre-divider from MPTPR) from SDRAM example configuration
|
||||
* 4 Number of refresh cycles per period
|
||||
* 64 Refresh cycle in ms per number of rows
|
||||
* --------------------------------------------
|
||||
* Divider = 4096 * 32 * 1000 / (4 * 64) = 512000
|
||||
*
|
||||
* 50 MHz => 50.000.000 / Divider = 98
|
||||
* 66 Mhz => 66.000.000 / Divider = 129
|
||||
* 80 Mhz => 80.000.000 / Divider = 156
|
||||
*/
|
||||
|
||||
/* periodic timer for refresh */
|
||||
#define CFG_MAMR_PTA 97 /* start with divider for 100 MHz */
|
||||
#define CFG_PTA_PER_CLK ((4096 * 32 * 1000) / (4 * 64))
|
||||
#define CFG_MAMR_PTA 98
|
||||
|
||||
/* refresh rate 15.6 us (= 64 ms / 4K = 62.4 / quad bursts) for <= 128 MBit */
|
||||
/*
|
||||
* For 16 MBit, refresh rates could be 31.3 us
|
||||
* (= 64 ms / 2K = 125 / quad bursts).
|
||||
* For a simpler initialization, 15.6 us is used instead.
|
||||
*
|
||||
* #define CFG_MPTPR_2BK_2K MPTPR_PTP_DIV32 for 2 banks
|
||||
* #define CFG_MPTPR_1BK_2K MPTPR_PTP_DIV64 for 1 bank
|
||||
*/
|
||||
#define CFG_MPTPR_2BK_4K MPTPR_PTP_DIV16 /* setting for 2 banks */
|
||||
#define CFG_MPTPR_1BK_4K MPTPR_PTP_DIV32 /* setting for 1 bank */
|
||||
|
||||
|
|
|
|||
|
|
@ -310,7 +310,6 @@ void start_armboot (void)
|
|||
if (getenv ("ethaddr")) {
|
||||
smc_set_mac_addr(gd->bd->bi_enetaddr);
|
||||
}
|
||||
eth_init(gd->bd);
|
||||
#endif /* CONFIG_DRIVER_SMC91111 || CONFIG_DRIVER_LAN91C96 */
|
||||
|
||||
/* Initialize from environment */
|
||||
|
|
|
|||
Loading…
Reference in New Issue