ARM: atmel: sama5d3xek: fix conflict between w1 and led
As the 1-wire and LED d2 use the same pin (PE25) on the EK board. So, make LED enable only when the 1-wire is disabled. Signed-off-by: Bo Shen <voice.shen@atmel.com> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This commit is contained in:
parent
124e3d3ce2
commit
ea1f2061bd
|
@ -49,11 +49,13 @@
|
|||
|
||||
#include "hw_version.h"
|
||||
|
||||
#ifdef CONFIG_W1_MASTER_GPIO
|
||||
struct w1_gpio_platform_data w1_pdata = {
|
||||
.pin = AT91_PIN_PE25,
|
||||
.ext_pullup_enable_pin = -EINVAL,
|
||||
.is_open_drain = 0,
|
||||
};
|
||||
#endif
|
||||
|
||||
#if defined(CONFIG_NAND_ATMEL)
|
||||
static struct atmel_nand_data nand_pdata = {
|
||||
|
@ -323,11 +325,13 @@ struct gpio_led leds[] = {
|
|||
.name = "d1",
|
||||
},
|
||||
}, {
|
||||
#ifndef CONFIG_W1_MASTER_GPIO
|
||||
.gpio = AT91_PIN_PE25,
|
||||
.active_low = 1,
|
||||
.led = {
|
||||
.name = "d2",
|
||||
},
|
||||
#endif
|
||||
},
|
||||
};
|
||||
|
||||
|
@ -353,6 +357,7 @@ static int at91sama5d3xek_mem_init(void)
|
|||
}
|
||||
mem_initcall(at91sama5d3xek_mem_init);
|
||||
|
||||
#ifdef CONFIG_W1_MASTER_GPIO
|
||||
static void ek_add_device_w1(void)
|
||||
{
|
||||
at91_set_gpio_input(w1_pdata.pin, 0);
|
||||
|
@ -361,6 +366,9 @@ static void ek_add_device_w1(void)
|
|||
|
||||
at91sama5d3xek_devices_detect_hw();
|
||||
}
|
||||
#else
|
||||
static void ek_add_device_w1(void) {}
|
||||
#endif
|
||||
|
||||
#ifdef CONFIG_POLLER
|
||||
/*
|
||||
|
|
Loading…
Reference in New Issue