/*
 * drivers/net/phy/marvell.c
 *
 * Driver for Marvell PHYs based on Linux driver
 */

#include <common.h>
#include <init.h>
#include <linux/mii.h>
#include <linux/ethtool.h>
#include <linux/phy.h>
#include <linux/smscphy.h>

/* Known PHY IDs */
#define MARVELL_PHY_ID_88E1101		0x01410c60
#define MARVELL_PHY_ID_88E1112		0x01410c90
#define MARVELL_PHY_ID_88E1111		0x01410cc0
#define MARVELL_PHY_ID_88E1118		0x01410e10
#define MARVELL_PHY_ID_88E1121R		0x01410cb0
#define MARVELL_PHY_ID_88E1145		0x01410cd0
#define MARVELL_PHY_ID_88E1149R		0x01410e50
#define MARVELL_PHY_ID_88E1240		0x01410e30
#define MARVELL_PHY_ID_88E1318S		0x01410e90
#define MARVELL_PHY_ID_88E1116R		0x01410e40
#define MARVELL_PHY_ID_88E1510		0x01410dd0

/* Mask used for ID comparisons */
#define MARVELL_PHY_ID_MASK		0xfffffff0

/* Marvell Register Page register */
#define MII_MARVELL_PHY_PAGE		22
#define MII_MARVELL_PHY_DEFAULT_PAGE	0

#define MII_M1011_PHY_SCR		0x10
#define MII_M1011_PHY_SCR_AUTO_CROSS	0x0060

#define MII_M1011_PHY_STATUS		0x11
#define MII_M1011_PHY_STATUS_1000	BIT(15)
#define MII_M1011_PHY_STATUS_100	BIT(14)
#define MII_M1011_PHY_STATUS_SPD_MASK	\
	(MII_M1011_PHY_STATUS_1000 | MII_M1011_PHY_STATUS_100)
#define MII_M1011_PHY_STATUS_FULLDUPLEX	BIT(13)
#define MII_M1011_PHY_STATUS_RESOLVED	BIT(11)
#define MII_M1011_PHY_STATUS_LINK	BIT(10)

#define MII_88E1121_PHY_MSCR_PAGE	2
#define MII_88E1121_PHY_MSCR		0x15
#define MII_88E1121_PHY_MSCR_TX_DELAY	BIT(4)
#define MII_88E1121_PHY_MSCR_RX_DELAY	BIT(5)
#define MII_88E1121_PHY_MSCR_DELAY_MASK	\
	(MII_88E1121_PHY_MSCR_RX_DELAY | MII_88E1121_PHY_MSCR_TX_DELAY)

/*
 * marvell_read_status
 *
 * Generic status code does not detect Fiber correctly!
 * Description:
 *   Check the link, then figure out the current state
 *   by comparing what we advertise with what the link partner
 *   advertises.  Start by checking the gigabit possibilities,
 *   then move on to 10/100.
 */
static int marvell_read_status(struct phy_device *phydev)
{
	int adv;
	int err;
	int lpa;
	int status = 0;

	/* Update the link, but return if there
	 * was an error */
	err = genphy_update_link(phydev);
	if (err)
		return err;

	if (AUTONEG_ENABLE == phydev->autoneg) {
		status = phy_read(phydev, MII_M1011_PHY_STATUS);
		if (status < 0)
			return status;

		lpa = phy_read(phydev, MII_LPA);
		if (lpa < 0)
			return lpa;

		adv = phy_read(phydev, MII_ADVERTISE);
		if (adv < 0)
			return adv;

		lpa &= adv;

		if (status & MII_M1011_PHY_STATUS_FULLDUPLEX)
			phydev->duplex = DUPLEX_FULL;
		else
			phydev->duplex = DUPLEX_HALF;

		status = status & MII_M1011_PHY_STATUS_SPD_MASK;
		phydev->pause = phydev->asym_pause = 0;

		switch (status) {
		case MII_M1011_PHY_STATUS_1000:
			phydev->speed = SPEED_1000;
			break;

		case MII_M1011_PHY_STATUS_100:
			phydev->speed = SPEED_100;
			break;

		default:
			phydev->speed = SPEED_10;
			break;
		}

		if (phydev->duplex == DUPLEX_FULL) {
			phydev->pause = lpa & LPA_PAUSE_CAP ? 1 : 0;
			phydev->asym_pause = lpa & LPA_PAUSE_ASYM ? 1 : 0;
		}
	} else {
		int bmcr = phy_read(phydev, MII_BMCR);

		if (bmcr < 0)
			return bmcr;

		if (bmcr & BMCR_FULLDPLX)
			phydev->duplex = DUPLEX_FULL;
		else
			phydev->duplex = DUPLEX_HALF;

		if (bmcr & BMCR_SPEED1000)
			phydev->speed = SPEED_1000;
		else if (bmcr & BMCR_SPEED100)
			phydev->speed = SPEED_100;
		else
			phydev->speed = SPEED_10;

		phydev->pause = phydev->asym_pause = 0;
	}

	return 0;
}

static int m88e1121_config_init(struct phy_device *phydev)
{
	u16 reg;
	int ret;

	ret = phy_write(phydev, MII_MARVELL_PHY_PAGE,
			MII_88E1121_PHY_MSCR_PAGE);
	if (ret < 0)
		return ret;

	/* Setup RGMII TX/RX delay */
	reg = phy_read(phydev, MII_88E1121_PHY_MSCR) &
		~MII_88E1121_PHY_MSCR_DELAY_MASK;
	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
	    phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID)
		reg |= MII_88E1121_PHY_MSCR_RX_DELAY;
	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
	    phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
		reg |= MII_88E1121_PHY_MSCR_TX_DELAY;
	ret = phy_write(phydev, MII_88E1121_PHY_MSCR, reg);
	if (ret < 0)
		return ret;

	phy_write(phydev, MII_MARVELL_PHY_PAGE, MII_MARVELL_PHY_DEFAULT_PAGE);
	if (ret < 0)
		return ret;

	/* Enable auto-crossover */
	ret = phy_write(phydev, MII_M1011_PHY_SCR,
			MII_M1011_PHY_SCR_AUTO_CROSS);
	if (ret < 0)
		return ret;

	/* Reset PHY */
	ret = phy_write(phydev, MII_BMCR,
			phy_read(phydev, MII_BMCR) | BMCR_RESET);
	if (ret < 0)
		return ret;

	return 0;
}

static struct phy_driver marvell_phys[] = {
{
	.phy_id		= MARVELL_PHY_ID_88E1121R,
	.phy_id_mask	= MARVELL_PHY_ID_MASK,
	.drv.name	= "Marvell 88E1121R",
	.features	= PHY_GBIT_FEATURES,
	.config_init	= m88e1121_config_init,
	.config_aneg	= genphy_config_aneg,
	.read_status	= marvell_read_status,
},
};

static int __init marvell_phy_init(void)
{
	return phy_drivers_register(marvell_phys, ARRAY_SIZE(marvell_phys));
}
fs_initcall(marvell_phy_init);