Since the qemu for aarch64 must use a virtual console for the second
serial port rather than emulating actual hardware, make sure the correct
device is specified so that a tty is actually started.
(From OE-Core rev: 5b720a69f0d181ab2de6032a6e3f5a0ee4a14302)
Signed-off-by: Randy Witt <randy.e.witt@linux.intel.com>
Signed-off-by: Ross Burton <ross.burton@intel.com>
Signed-off-by: Richard Purdie <richard.purdie@linuxfoundation.org>
qemu can freeze and stop responding if the socket buffer connected to a tcp
serial connection fills up. This happens of course when the reader of
the serial data doesn't actually read it.
This happened in the qemurunner code, because after checking for the
"login:" sentinel, data was never again read from the serial connection.
This patch solves the potential freeze by adding a thread to continuously
read the data from the console and log it. So it also will give a full log
of the console, rather than just up to the login prompt.
To simplify this patch, another serial port was also added to use for the
sole purpose of watching for the sentinel as well as being the interactive
serial port. This will also prevent the possibility of lots of debug
data on the console preventing the sentinel value from being seen due to
interleaved text.
(From OE-Core rev: 2da3fee6b6d9f4dd4c4cb529f4ba393c20aa0f13)
Signed-off-by: Randy Witt <randy.e.witt@linux.intel.com>
Signed-off-by: Ross Burton <ross.burton@intel.com>
Signed-off-by: Richard Purdie <richard.purdie@linuxfoundation.org>
Add machine qemuarm64. The configure files are derived from linaro.
Update:
* rename genericarmv8 to qemuarm64 for coordination in oe-core
* include qemu.inc then remove common part of config
* disable using autoserial
* move arch-armv8.inc from machine/include/arm64 to machine/include/arm
[YOCTO #6487]
(From OE-Core rev: d7314c3bc804b7bcc921b0a6c5b63d71ca2e73db)
Signed-off-by: Kai Kang <kai.kang@windriver.com>
Signed-off-by: Richard Purdie <richard.purdie@linuxfoundation.org>
Randy Witt
Kai Kang