Commit graph

3 commits

Author SHA1 Message Date
Mark Asselstine
c88ed4cb2e sheevaplug: correct SDRAM address control register
value

The SheevaPlug DevKit is shipped with 4x8 by 1Gb DDR devices in
two banks for a total of 512MB of RAM. Based on this configuration
the existing values for SDRAM address control register are incorrect
and result in random kernel oops as memory is incorrectly accessed
(while for example extracting a large tarball such as a rootfs).
Based on the hardware configuration along with the supporting
documentation from Marvell these are the correct values, as
well this change mimics values previously used in Marvell's own
u-boot git tree for the SheevaPlug.

Other variants of the hardware such as the PogoPlug and TonidoPlug
may have different memory configurations but to properly support
those additional board directories should be maintained or a better
system to support other kwb*.cfg is needed.

Tested on SheevaPlug DevKit.

Signed-off-by: Mark Asselstine <mark.asselstine@windriver.com>
2009-11-27 16:26:12 -06:00
Prafulla Wadaskar
7809fbb9aa Kirkwood: Sheevaplug: Add kwimage configuration file
Signed-off-by: Prafulla Wadaskar <prafulla@marvell.com>
2009-09-10 22:58:48 +02:00
Prafulla Wadaskar
55dd4ba541 Marvell Sheevaplug Board support
Reference:
http://plugcomputer.org/
http://openplug.org/plugwiki/index.php/Das_U-boot_plug_support

This patch is tested for-
1. Boot from DRAM/NAND flash
2. File transfer using tftp
3. NAND flash read/write/erase
4. Linux kernel and RFS Boot from NAND
5. Enabled USB PHY init for kernel need
6. Boot from USB supported

Note: to boot Kirkwood kernel with USB support,
	you should add "usb start" in the boot sequence

Signed-off-by: Prafulla Wadaskar <prafulla@marvell.com>
2009-07-18 18:46:09 +02:00