Commit graph

7 commits

Author SHA1 Message Date
Jon Loeliger
7f5c015774 include/configs/[g-o]*: Cleanup BOOTP and lingering CFG_CMD_*.
Explicitly add in default CONFIG_BOOTP_* options where cmd_confdefs.h
used to be included but CONFIG_BOOTP_MASK was not defined.

Remove lingering references to CFG_CMD_* symbols.

Signed-off-by: Jon Loeliger <jdl@freescale.com>
2007-07-10 09:38:02 -05:00
Jon Loeliger
5dc11a5119 include/configs: Use new CONFIG_CMD_* in various m* named board config files.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
2007-07-05 11:05:02 +02:00
Wolfgang Denk
0c8721a466 Cleanup (PPC4xx is AMCC now) 2005-09-23 11:05:55 +02:00
wdenk
e2ffd59b4d * Code cleanup, mostly for GCC-3.3.x
* Cleanup confusing use of CONFIG_ETH*ADDR - ust his only to
  pre-define a MAC address; use CONFIG_HAS_ETH* to enable support for
  additional ethernet addresses.

* Cleanup drivers/i82365.c - avoid duplication of code

* Fix bogus "cannot span across banks" flash error message

* Add support for CompactFlash for the CPC45 Board.
2004-12-31 09:32:47 +00:00
wdenk
a5bbcc3c53 * Patches by Sean Chang, 09 Aug 2004:
- Added support for both 8 and 16 bit mode access to System ACE CF
    through MPU.
  - Fixed missing System ACE CF device during get FAT partition info
    in fat_register_device function.
  - Enabled System ACE CF support on ML300.

* Patch by Sean Chang, 09 Aug 2004:
  Synch defines for saveenv and do_saveenv functions so they get
  compiled under the same statement.
2004-09-29 22:55:14 +00:00
wdenk
a06752e36b * Patch by Sean Chang, 9 Aug 2004:
- Added I2C support for ML300.
  - Added support for ML300 to read out its environment information
    stored on the EEPROM.
  - Added support to use board specific parameters as part of
    U-Boot's environment information.
  - Updated MLD files to support configuration for new features
    above.

* Patches by Travis Sawyer, 5 Aug 2004:
  - Remove incorrect bridge settings for eth group 6
  - Add call to setup bridge in ppc_440x_eth_initialize
  - Fix ppc_440x_eth_init to reset the phy only if its the
    first time through, otherwise, just check the phy for the
    autonegotiated speed/duplex.  This allows the use of netconsole
  - only print the speed/duplex the first time the phy is reset.
2004-09-29 22:43:59 +00:00
wdenk
028ab6b598 * Patch by Peter Ryser, 20 Feb 2004:
Add support for the Xilinx ML300 platform

* Patch by Stephan Linz, 17 Feb 2004:
  Fix watchdog support for NIOS

* Patch by Josh Fryman, 16 Feb 2004:
  Fix byte-swapping for cfi_flash.c for different bus widths

* Patch by Jon Diekema, 14 Jeb 2004:
  Remove duplicate "FPGA Support" notes from the README file
2004-02-23 23:54:43 +00:00