u-boot/board/phytec/pcm058
Stefano Babic 876a25d289 mx6: Add Phytec PCM058 i.MX6 Quad
Add Phytec-i.MX6 SOM with NAND

  Support:
   - 1GB RAM
   - Ethernet
   - SPI-NOR Flash
   - NAND (1024 MB)
   - external SD
   - UART

Signed-off-by: Stefano Babic <sbabic@denx.de>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
2016-07-12 17:58:48 +02:00
..
Kconfig mx6: Add Phytec PCM058 i.MX6 Quad 2016-07-12 17:58:48 +02:00
MAINTAINERS mx6: Add Phytec PCM058 i.MX6 Quad 2016-07-12 17:58:48 +02:00
Makefile mx6: Add Phytec PCM058 i.MX6 Quad 2016-07-12 17:58:48 +02:00
pcm058.c mx6: Add Phytec PCM058 i.MX6 Quad 2016-07-12 17:58:48 +02:00
README mx6: Add Phytec PCM058 i.MX6 Quad 2016-07-12 17:58:48 +02:00

Board information
-----------------

The SBC produced by Phytec has a SOM based on a i.MX6Q.
The SOM is sold in two versions, with eMMC or with NAND. Support
here is for the SOM with NAND.
The evaluation board "phyBoard-Mira" is thought to be used
together with the SOM.

More information on the board can be found on manufacturer's
website:

http://www.phytec.de/produkt/single-board-computer/phyboard-mira/
http://www.phytec.de/fileadmin/user_upload/images/content/1.Products/SOMs/phyCORE-i.MX6/L-808e_1.pdf

Building U-Boot
-------------------------------

$ make pcm058_defconfig
$ make

This generates the artifacts SPL and u-boot.img.
The SOM can boot from NAND or from SD-Card, having the SPI-NOR
as second option.
The dip switch "DIP-1" on the board let choose between
NAND and SD.

DIP-1 set to off:	Boot first from NAND, then try SPI
DIP-1 set to on:	Boot first from SD, then try SPI

The bootloader was tested with DIP-1 set to on. If a SD-card
is present, then the RBL tries to load SPL from the SD Card, if not,
RBL loads from SPI-NOR. The SPL tries then to load from the same
device where SPL was loaded (SD or SPI). Booting from NAND is
not supported.