u-boot/board/solidrun/mx6cuboxi
Fabio Estevam c5f18a0b69 MAINTAINERS/mailmap: Update my email address
Update my email address to the NXP account.

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
2016-01-11 11:22:43 -05:00
..
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS MAINTAINERS/mailmap: Update my email address 2016-01-11 11:22:43 -05:00
Makefile mx6: Add initial SPL support for HummingBoard-i2eX 2015-04-22 14:39:06 +02:00
mx6cuboxi.c mx6cuboxi: Remove obsolete comment 2016-01-10 10:50:53 +01:00
README mx6cuboxi: Mention Cubox-i in the README 2015-05-15 19:21:23 +02:00

How to use U-boot on Solid-run mx6 Hummingboard and Cubox-i
-----------------------------------------------------------

- Build U-boot for Hummingboard/Cubox-i:

$ make mrproper
$ make mx6cuboxi_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card in the board, power it up and U-boot messages should
come up.