u-boot/board/wandboard
Fabio Estevam 14da759fb5 wandboard: Return from cpu_eth_init() directly
There is no need to print an error message when cpu_eth_init() fails because
net/eth.c already prints it.

In order to simplify the code, just return the value from cpu_eth_init(bis)
directly.

Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
2014-01-13 11:52:27 +01:00
..
Makefile board: arm: convert makefiles to Kbuild style 2013-11-01 11:42:12 -04:00
README wandboard: README: Include the quad version 2013-11-04 09:56:25 +01:00
wandboard.c wandboard: Return from cpu_eth_init() directly 2014-01-13 11:52:27 +01:00

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 dual lite and mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard Dual Lite version:

$ make wandboard_dl_config
$ make

To build U-Boot for the Wandboard Solo version:

$ make wandboard_solo_config
$ make

To build U-Boot for the Wandboard Quad version:

$ make wandboard_quad_config
$ make

Flashing U-boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'u-boot.imx' binary must be
flashed into the SD card;

$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync

(Note - the SD card node may vary, so adjust this as needed).

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-boot messages will appear in the serial console.