sysmo-bts
/
u-boot
9
0
Fork 0
Code Pull Requests Releases Activity
u-boot/board/freescale/mx6ul_14x14_evk
History
Peng Fan df67490488 imx: mx6ul_14x14_evk: support lcdif display 
Support lcdif display:
1. Add pinmux and pad settings for LCDIF
2. Introduce setup_lcd to do the settings for LCDIF
3. Enable VIDEO related macros in board header files
4. Add a new env videomode which is needed by mxsfb.c. The
   settings for videomode in this patch is for TFT43AB.
5. Tested on mx6ul 14x14/9x9 evk.

Signed-off-by: Peng Fan <Peng.Fan@freescale.com>
Cc: Stefano Babic <sbabic@denx.de>
 		2015-11-12 17:40:53 +01:00
..
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS imx: boards: Add maintainers info 2015-09-24 11:28:59 +02:00
Makefile imx: mx6ul_14x14_evk add basic board support 2015-08-02 11:05:09 +02:00
README mx6ul_14x14_evk: Add a README file 2015-09-13 10:54:37 +02:00
mx6ul_14x14_evk.c imx: mx6ul_14x14_evk: support lcdif display 2015-11-12 17:40:53 +01:00

README 

How to use U-boot on Freescale MX6UL 14x14 EVK
-----------------------------------------------

- Build U-boot for MX6UL 14x14 EVK:

$ make mrproper
$ make mx6ul_14x14_evk_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

SW601: 0 0 1 0
Sw602: 1 0

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the push buttons)

- Insert the micro SD card in the board, power it up and U-boot messages should
come up.