sysmo-bts
/
u-boot
9
0
Fork 0
Code Pull Requests Releases Activity
u-boot/board/engicam/icorem6
History
Jagan Teki 5bdf6b574a imx6: icorem6: Rename engicam icorem6 defconfig files 
Rename defconfig files for better compatible with
respective board names and dts files.

Cc: Stefano Babic <sbabic@denx.de>
Cc: Matteo Lisi <matteo.lisi@engicam.com>
Cc: Michael Trimarchi <michael@amarulasolutions.com>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
 		2016-12-16 18:38:54 +01:00
..
Kconfig arm: imx: Add Engicam i.CoreM6 QDL Starter Kit initial support 2016-10-26 16:53:16 +02:00
MAINTAINERS imx6: icorem6: Rename engicam icorem6 defconfig files 2016-12-16 18:38:54 +01:00
Makefile arm: imx: Add Engicam i.CoreM6 QDL Starter Kit initial support 2016-10-26 16:53:16 +02:00
README imx6: icorem6: Rename engicam icorem6 defconfig files 2016-12-16 18:38:54 +01:00
icorem6.c imx6: icorem6: Add framebuffer support 2016-12-16 17:15:27 +01:00

README 

How to use U-Boot on Engicam i.CoreM6 Solo/DualLite and Quad/Dual Starter Kit:
-----------------------------------------------------------------------------

$ make mrproper

- Configure U-Boot for Engicam i.CoreM6 Quad/Dual:
$ make imx6q_icore_mmc_defconfig

- Configure U-Boot for Engicam i.CoreM6 Solo/DualLite:
$ make imx6dl_icore_mmc_defconfig

- Build U-Boot
$ make

This will generate the SPL image called SPL and the u-boot-dtb.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot-dtb.img image into the micro SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

MMC Boot: JM3 Closed

- Connect the Serial cable between the Starter Kit and the PC for the console.
(J28 is the Linux Serial console connector)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.