u-boot/board/freescale/mx6ul_14x14_evk
Fabio Estevam ab25f0f69f mx6ul_14x14_ev: Enable the CCGR clocks earlier
To be in the safe side we need to enable the CCGR clocks prior
to calling arch_cpu_init().

Inspired by Tim Harvey's commit d783c2744f ("imx: ventana: fix boot to SD").

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Reviewed-by: Eric Nelson <eric@nelint.com>
Tested-by: Eric Nelson <eric@nelint.com>
2016-09-06 18:22:48 +02:00
..
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS MAINTAINERS: Update Peng Fan's email address 2016-03-02 14:48:52 +01:00
Makefile imx: mx6ul_14x14_evk add basic board support 2015-08-02 11:05:09 +02:00
mx6ul_14x14_evk.c mx6ul_14x14_ev: Enable the CCGR clocks earlier 2016-09-06 18:22:48 +02:00
README Use correct spelling of "U-Boot" 2016-02-06 12:00:59 +01:00

How to use U-Boot on Freescale MX6UL 14x14 EVK
-----------------------------------------------

- Build U-Boot for MX6UL 14x14 EVK:

$ make mrproper
$ make mx6ul_14x14_evk_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

SW601: 0 0 1 0
Sw602: 1 0

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the push buttons)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.