u-boot/board/wandboard
Fabio Estevam 7bcb983feb wandboard: Enable HDMI splashscreen
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
2013-06-03 14:26:14 +02:00
..
Makefile Add initial support for Wandboard dual lite and solo. 2013-03-20 11:47:37 +01:00
README wandboard: fix typo in README 2013-05-16 17:44:46 +02:00
wandboard.c wandboard: Enable HDMI splashscreen 2013-06-03 14:26:14 +02:00

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has two variants: one version based
on mx6 dual lite and another one based on mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard Dual Lite version:

$ make wandboard_dl_config
$ make

To build U-Boot for the Wandboard Solo version:

$ make wandboard_solo_config
$ make

Flashing U-boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'u-boot.imx' binary must be
flashed into the SD card;

$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync

(Note - the SD card node may vary, so adjust this as needed).

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-boot messages will appear in the serial console.