u-boot/board/solidrun/hummingboard
Stefan Roese 7731745c13 arm: mx6: Change defines ENET_xxMHz to ENET_xxMHZ (no CamelCase)
As checkpatch complaines about these camel-case defines, lets change
them to only use upper-case characters.

Signed-off-by: Stefan Roese <sr@denx.de>
Acked-by: Heiko Schocher <hs@denx.de>
Cc: Fabio Estevam <fabio.estevam@freescale.com>
Cc: Jon Nettleton <jon.nettleton@gmail.com>
Cc: Stefano Babic <sbabic@denx.de>
Reviewed-by: Fabio Estevam <fabio.estevam@freescale.com>
2014-12-01 10:20:20 +01:00
..
hummingboard.c arm: mx6: Change defines ENET_xxMHz to ENET_xxMHZ (no CamelCase) 2014-12-01 10:20:20 +01:00
Kconfig kconfig: arm: introduce symbol for ARM CPUs 2014-10-29 09:02:09 -04:00
MAINTAINERS Add board MAINTAINERS files 2014-07-30 08:48:06 -04:00
Makefile mx6: Add initial support for the Hummingboard solo 2014-01-15 10:33:25 +01:00
README mx6: Add initial support for the Hummingboard solo 2014-01-15 10:33:25 +01:00
solo.cfg mx6: Add initial support for the Hummingboard solo 2014-01-15 10:33:25 +01:00

U-Boot for SolidRun Hummingboard
--------------------------------

This file contains information for the port of U-Boot to the Hummingboard.

For more details about Hummingboard, please refer to:
http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware

(Carrier-One was the previous name of Hummingboard).

Building U-boot for Hummingboard
--------------------------------

To build U-Boot for the Hummingboard Solo version:

$ make hummingboard_solo_config
$ make

Flashing U-boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'u-boot.imx' binary must be
flashed into the SD card:

$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=1k seek=1; sync

(Note - the SD card node may vary, so adjust this as needed).

Also, a more detailed explanation on how to format the SD card is available
at doc/README.imximage.

- Insert the micro SD card into the slot located in the bottom of the board

- Connect a 3.3V USB to serial converter cable to the host PC. The MX6 UART
signals are available in the 26 pin connector as shown at:
http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware
(Check for "26 pin header layout").

- Power up the board via USB cable (CON201) and U-boot messages will appear in
the serial console.