u-boot/board/sunxi/gmac.c
Hans de Goede fc8991c61c sunxi: Fix gmac not working due to cpu_eth_init no longer being called
cpu_eth_init is no longer called for dm enabled eth drivers, this
was causing the sunxi gmac eth controller to no longer work in u-boot.

This commit fixes this by calling the clock, reset and pinmux setup
function from s_init() and enabling the phy power pin (if any) from
board_init().

The enabling of phy power cannot be done from s_init because it uses dm
and dm is not ready yet at this point.

Note that the mdelay is dropped as the phy gets enabled much earlier
now, so it is no longer needed.

Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Ian Campbell <ijc@hellion.org.uk>
Tested-by: Karsten Merker <merker@debian.org>
Tested-by: Michael Haas <haas@computerlinguist.org>
2016-03-23 22:04:13 +01:00

83 lines
2.6 KiB
C

#include <common.h>
#include <netdev.h>
#include <miiphy.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <asm/arch/clock.h>
#include <asm/arch/gpio.h>
void eth_init_board(void)
{
int pin;
struct sunxi_ccm_reg *const ccm =
(struct sunxi_ccm_reg *)SUNXI_CCM_BASE;
/* Set up clock gating */
#ifdef CONFIG_SUNXI_GEN_SUN6I
setbits_le32(&ccm->ahb_reset0_cfg, 0x1 << AHB_RESET_OFFSET_GMAC);
setbits_le32(&ccm->ahb_gate0, 0x1 << AHB_GATE_OFFSET_GMAC);
#else
setbits_le32(&ccm->ahb_gate1, 0x1 << AHB_GATE_OFFSET_GMAC);
#endif
/* Set MII clock */
#ifdef CONFIG_RGMII
setbits_le32(&ccm->gmac_clk_cfg, CCM_GMAC_CTRL_TX_CLK_SRC_INT_RGMII |
CCM_GMAC_CTRL_GPIT_RGMII);
setbits_le32(&ccm->gmac_clk_cfg,
CCM_GMAC_CTRL_TX_CLK_DELAY(CONFIG_GMAC_TX_DELAY));
#else
setbits_le32(&ccm->gmac_clk_cfg, CCM_GMAC_CTRL_TX_CLK_SRC_MII |
CCM_GMAC_CTRL_GPIT_MII);
#endif
#ifndef CONFIG_MACH_SUN6I
/* Configure pin mux settings for GMAC */
for (pin = SUNXI_GPA(0); pin <= SUNXI_GPA(16); pin++) {
#ifdef CONFIG_RGMII
/* skip unused pins in RGMII mode */
if (pin == SUNXI_GPA(9) || pin == SUNXI_GPA(14))
continue;
#endif
sunxi_gpio_set_cfgpin(pin, SUN7I_GPA_GMAC);
sunxi_gpio_set_drv(pin, 3);
}
#elif defined CONFIG_RGMII
/* Configure sun6i RGMII mode pin mux settings */
for (pin = SUNXI_GPA(0); pin <= SUNXI_GPA(3); pin++) {
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
sunxi_gpio_set_drv(pin, 3);
}
for (pin = SUNXI_GPA(9); pin <= SUNXI_GPA(14); pin++) {
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
sunxi_gpio_set_drv(pin, 3);
}
for (pin = SUNXI_GPA(19); pin <= SUNXI_GPA(20); pin++) {
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
sunxi_gpio_set_drv(pin, 3);
}
for (pin = SUNXI_GPA(25); pin <= SUNXI_GPA(27); pin++) {
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
sunxi_gpio_set_drv(pin, 3);
}
#elif defined CONFIG_GMII
/* Configure sun6i GMII mode pin mux settings */
for (pin = SUNXI_GPA(0); pin <= SUNXI_GPA(27); pin++) {
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
sunxi_gpio_set_drv(pin, 2);
}
#else
/* Configure sun6i MII mode pin mux settings */
for (pin = SUNXI_GPA(0); pin <= SUNXI_GPA(3); pin++)
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
for (pin = SUNXI_GPA(8); pin <= SUNXI_GPA(9); pin++)
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
for (pin = SUNXI_GPA(11); pin <= SUNXI_GPA(14); pin++)
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
for (pin = SUNXI_GPA(19); pin <= SUNXI_GPA(24); pin++)
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
for (pin = SUNXI_GPA(26); pin <= SUNXI_GPA(27); pin++)
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA_GMAC);
#endif
}