u-boot/board/wandboard
Otavio Salvador 8bc7c48749 wandboard: add Future Eletronics 7" WVGA LCD extension board
This adds support for the 7" WVGA produced by Future Eletronics and
make it dynamically detect if it is connected or not based on the
touchscreen controller.

Signed-off-by: Otavio Salvador <otavio@ossystems.com.br>
Acked-by: Stefano Babic <sbabic@denx.de>
2014-05-09 15:21:16 +02:00
..
Makefile board: arm: convert makefiles to Kbuild style 2013-11-01 11:42:12 -04:00
README wandboard: README: Include the quad version 2013-11-04 09:56:25 +01:00
wandboard.c wandboard: add Future Eletronics 7" WVGA LCD extension board 2014-05-09 15:21:16 +02:00

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 dual lite and mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard Dual Lite version:

$ make wandboard_dl_config
$ make

To build U-Boot for the Wandboard Solo version:

$ make wandboard_solo_config
$ make

To build U-Boot for the Wandboard Quad version:

$ make wandboard_quad_config
$ make

Flashing U-boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'u-boot.imx' binary must be
flashed into the SD card;

$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync

(Note - the SD card node may vary, so adjust this as needed).

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-boot messages will appear in the serial console.