u-boot/board/freescale/p1022ds
Timur Tabi 7a946961c7 powerpc/p1022ds: fix DIU/LBC switching with NAND enabled
In order for indirect mode on the PIXIS to work properly, both chip selects
need to be set to GPCM mode, otherwise writes to the chip select base
addresses will not actually post to the local bus -- they'll go to the
NAND controller instead.  Therefore, we need to set BR0 and BR1 to GPCM
mode before switching to indirect mode.

Signed-off-by: Timur Tabi <timur@freescale.com>
Signed-off-by: Andy Fleming <afleming@freescale.com>
2012-08-08 17:13:37 -05:00
..
ddr.c powerpc/mpc8xxx: Merge entries in DDR speed table 2011-10-09 17:57:53 -05:00
diu.c powerpc/p1022ds: fix DIU/LBC switching with NAND enabled 2012-08-08 17:13:37 -05:00
law.c powerpc: add support for the Freescale P1022DS reference board 2010-07-16 10:55:10 -05:00
Makefile punt unused clean/distclean targets 2011-10-15 22:20:36 +02:00
p1022ds.c powerpc/p1022ds: add support for SPI and SD boot 2012-08-08 17:13:37 -05:00
README doc: cleanup - move board READMEs into respective board directories 2012-07-29 15:42:02 +02:00
tlb.c powerpc/p1022ds: add support for SPI and SD boot 2012-08-08 17:13:37 -05:00

Overview
--------
P1022ds is a Low End Dual core platform supporting the P1022 processor
of QorIQ series. P1022 is an e500 based dual core SOC.


Pin Multiplex(hwconfig setting)
-------------------------------
Add the environment 'usb2', 'audclk' and 'tdm' to support pin multiplex
via hwconfig, i.e:
'setenv hwconfig usb2' to enable USB2 and disable eTsec2
'setenv hwconfig tdm' to enable TDM and disable Audio
'setenv hwconfig audclk:12' to enable Audio(codec clock sources is 12MHz)
 and disable TDM
'setenv hwconfig 'usb2;tdm' to enable USB2 and TDM, disable eTsec2 and Audio
'setenv hwconfig 'usb2;audclk:11' to enable USB2 and Audio(codec clock sources
 is 11MHz), disable eTsec2 and TDM

Warning: TDM and AUDIO can not enable simultaneous !
and AUDIO codec clock sources only setting as 11MHz or 12MHz !
'setenv hwconfig 'audclk:12;tdm'	--- error !
'setenv hwconfig 'audclk:11;tdm'	--- error !
'setenv hwconfig 'audclk:10'		--- error !