u-boot

History

Jagan Teki 97bb1f0bcc engicam: icorem6: Fix config files Config file names on MAINTAINERS and README in board/engicam/icorem6 seems to be wrong, hence fixed the same. Cc: Stefano Babic <sbabic@denx.de> Cc: Michael Trimarchi <michael@amarulasolutions.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>		2016-11-05 10:09:10 -04:00
..
Kconfig	arm: imx: Add Engicam i.CoreM6 QDL Starter Kit initial support	2016-10-26 16:53:16 +02:00
MAINTAINERS	engicam: icorem6: Fix config files	2016-11-05 10:09:10 -04:00
Makefile	arm: imx: Add Engicam i.CoreM6 QDL Starter Kit initial support	2016-10-26 16:53:16 +02:00
README	engicam: icorem6: Fix config files	2016-11-05 10:09:10 -04:00
icorem6.c	imx6: icorem6: Add NAND support	2016-10-26 18:59:57 +02:00

README

How to use U-Boot on Engicam i.CoreM6 DualLite/Solo and Quad/Dual Starter Kit:
-----------------------------------------------------------------------------

- Configure U-Boot for Engicam i.CoreM6 QDL:

$ make mrproper
$ make imx6qdl_icore_mmc_defconfig

- Build for i.CoreM6 DualLite/Solo

$ make

- Build for i.CoreM6 Quad/Dual

$ make DEVICE_TREE=imx6q-icore

This will generate the SPL image called SPL and the u-boot-dtb.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot-dtb.img image into the micro SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

MMC Boot: JM3 Closed

- Connect the Serial cable between the Starter Kit and the PC for the console.
(J28 is the Linux Serial console connector)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.

- Note: For loading Linux on Quad/Dual modules set the dtb as
  icorem6qdl> setenv fdt_file imx6q-icore.dtb