Validate RTCP packets before processing them.
* Validate that the received packet is of a minimum length and apply the
RFC3550 RTCP packet validation checks.
* Fixed potentially reading garbage beyond the received RTCP record data.
* Fixed rtp->themssrc only being set once when the remote could change
the SSRC. We would effectively stop handling the RTCP statistic records.
* Fixed rtp->themssrc to not treat a zero value as special by adding
rtp->themssrc_valid to indicate if rtp->themssrc is available.
ASTERISK-27274
Make strict RTP learning more flexible.
Direct media can cause strict RTP to attempt to learn a remote address
again before it has had a chance to learn the remote address the first
time. Because of the rapid relearn requests, strict RTP could latch onto
the first remote address and fail to latch onto the direct media remote
address. As a result, you have one way audio until the call is placed on
and off hold.
The new algorithm learns remote addresses for a set time (1.5 seconds)
before locking the remote address. In addition, we must see a configured
number of remote packets from the same address in a row before switching.
* Fixed strict RTP learning from always accepting the first new address
packet as the new stream.
* Fixed strict RTP to initialize the expected sequence number with the
last received sequence number instead of the last transmitted sequence
number.
* Fixed the predicted next sequence number calculation in
rtp_learning_rtp_seq_update() to handle overflow.
ASTERISK-27252
Change-Id: Ia2d3aa6e0f22906c25971e74f10027d96525f31c
Incoming requests with non sip(s) URIs in the Request, To, From
or Contact URIs are now rejected with
PJSIP_SC_UNSUPPORTED_URI_SCHEME (416). This is performed in
pjsip_message_filter (formerly pjsip_message_ip_updater) and is
done at pjproject's "TRANSPORT" layer before a request can even
reach the distributor.
URIs read by res_pjsip_outbound_publish from pjsip.conf are now
also checked for both length and sip(s) scheme. Those URIs read
by outbound registration and aor were already being checked for
scheme but their error messages needed to be updated to include
scheme failure as well as length failure.
Change-Id: Ibb2f9f1d2dc7549da562af4cbd9156c44ffdd460
The Websocket implementation will steal the underlying stream of
TCP/TLS sessions. This results in an error message being output
about a stream not being present when in reality this is actually
fine.
This change moves it to a debug message instead.
Change-Id: I66cc639080b4b4599beadb4faa7d313f2721d094
* The way that we were looking at XML elements for CalDAV was extremely
fragile, so use SAX2 for increased robustness.
* Don't complain about a 'channel' not be specified if autoreminder is
not set. Assume that if 'channel' is not set, we don't want to be
notified.
* Fix some truncated CLI output in 'calendar show calendar' and make the
'Autoreminder' description a bit more clear
ASTERISK-24588 #close
Reported by: Stefan Gofferje
ASTERISK-25523 #close
Reported by: Jesper
Change-Id: I200d11afca6a47e7d97888f286977e2e69874b2c
Multicast/Unicast RTP do not use SDP so we need to use a format that
cleanly maps to one of the static RTP payload types. Without this
change, an Originate to a Multicast or Unicast channel without a format
specified would produce no audio on the receiving device.
ASTERISK-21399 #close
Reported by: Tzafrir Cohen
Change-Id: I97e332b566e85da04b0004b9b0daae746cfca0e3
A new endpoint parameter "incoming_mwi_mailbox" allows Asterisk to
receive unsolicited MWI NOTIFY requests and make them available to
other modules via the stasis message bus.
res_pjsip_pubsub has a new handler "pubsub_on_rx_mwi_notify_request"
that parses a simple-message-summary body and, if
endpoint->incoming_mwi_account is set, calls ast_publish_mwi_state
with the voice-message counts from the message.
Change-Id: I08bae3d16e77af48fcccc2c936acce8fc0ef0f3c
In 45744fc53, I mistakenly broke SDP media address rewriting by
misinterpreting which address was checked in the localnet comparison.
Instead of checking the remote peer address to decide whether we need
media address rewriting, we check our local media address: if it's
local, then we rewrite. This feels awkward, but works and even made
directmedia work properly if you set local_net. (For the record: for
local peers, the SDP media rewrite code is not called, so the
comparison does no harm there.)
ASTERISK-27248 #close
Change-Id: I566be1c33f4d0a689567d451ed46bab9c3861d4f
MS-SQL has no native Enum-type support and therefore
needs to work with constraints.
Since these constraints need unique names the suggested approach
referenced in the following alembic documentation has been applied:
http://bit.ly/2x9r8pb
ASTERISK-27255 #close
Change-Id: I8b579750dae0c549f1103ee50172644afb9b2f95
* WaitForSilence completes successfully if it receives no media in the
specified timeout, but when acting as WaitForNoise that logic needs
to be reversed.
* Use standard argument parsing macros and add some error checking for
invalid values.
* The documentation indicated that the first argument to both
WaitForSilence and WaitForNoise was required when it was not. Update
the documentation to reflect that.
* Wrap up some behavior in structs to avoid boolean checks all over the
place.
ASTERISK-24066 #close
Reported by: M vd S
Change-Id: I01d40adc5b63342bb5018a1bea2081a0aa191ef9
In handle_request_invite, when processing a pickup, a call
is made to get_sip_pvt_from_replaces to locate the pvt for
the subscription. The pvt is assumed to be valid when zero
is returned indicating no error, and is dereferenced which
can cause a crash if it was not found.
This change checks the not found case and returns -1 which
allows the calling code to fail appropriately.
ASTERISK-27217 #close
Reported-by: Bryan Walters
Change-Id: I6bee92b8b8b85fcac3fd66f8c00ab18bc1765612
If an error occurs during a bridge impart it's possible that
the "bridge_after" callback might try to run before
control_swap_channel_in_bridge has been signalled to continue.
Since control_swap_channel_in_bridge is holding the control lock
and the callback needs it, a deadlock will occur.
* control_swap_channel_in_bridge now only holds the control
lock while it's actually modifying the control structure and
releases it while the bridge impart is running.
* bridge_after_cb is now tolerant of impart failures.
Change-Id: Ifd239aa93955b3eb475521f61e284fcb0da2c3b3
If directmedia=yes is configured, when call is answered, Asterisk sends reINVITE
to both parties to set up media path directly between the endpoints.
In this reINVITE msg SDP origin line (o=) contains IP address of endpoint
instead of IP of asterisk. This behavior violates RFC3264, sec 8:
"When issuing an offer that modifies the session,
the "o=" line of the new SDP MUST be identical to that in the
previous SDP, except that the version in the origin field MUST
increment by one from the previous SDP."
This patch assures IP address of Asterisk is always sent in
SDP origin line.
ASTERISK-17540
Reported by: saghul
Change-Id: I533a047490c43dcff32eeca8378b2ba02345b64e
Added include for postgresql ENUM type and
redefined values in the same way as in the
other migration scripts.
ASTERISK-27254 #close
Change-Id: Id667304cdf3891b1c2f7d35fab3e2a84026159fa
Asterisk is able to use libSRTP 2.0.x. However since libSRTP 2.1.x, the macro
SRTP_AES_ICM got renamed to SRTP_AES_ICM_128. Beside to still compile with
previous versions of libSRTP, this change allows libSRTP 2.1.x as well.
ASTERISK-27253 #close
Change-Id: I2e6eb3c3bc844fee8a624060a2eb6f182dc70315
When rtp_keepalive is on for a PJSIP endpoint dialing to another
Asterisk instance also using PJSIP, Asterisk will continue to print
warning messages about not being able to send frames of a certain
type. This suppresses that warning message.
Change-Id: I0332a05519d7bda9cacfa26d433909ff1909be67
Some formats are able to handle short reads while others are not, so
restore the previous behavior for the format modules so that we don't
have spurious errors when playing back files.
ASTERISK-27232 #close
Reported by: Jens T.
Change-Id: Iab7f52b25a394f277566c8a2a4b15a692280a300
In 2dee95cc (ASTERISK-27024) and 776ffd77 (ASTERISK-26879) there was
confusion about whether the transport_state->localnet ACL has ALLOW or
DENY semantics.
For the record: the localnet has DENY semantics, meaning that "not in
the list" means ALLOW, and the local nets are in the list.
Therefore, checks like this look wrong, but are right:
/* See if where we are sending this request is local or not, and if
not that we can get a Contact URI to modify */
if (ast_apply_ha(transport_state->localnet, &addr) != AST_SENSE_ALLOW) {
ast_debug(5, "Request is being sent to local address, "
"skipping NAT manipulation\n");
(In the list == localnet == DENY == skip NAT manipulation.)
And conversely, other checks that looked right, were wrong.
This change adds two macro's to reduce the confusion and uses those
instead:
ast_sip_transport_is_nonlocal(transport_state, addr)
ast_sip_transport_is_local(transport_state, addr)
ASTERISK-27248 #close
Change-Id: Ie7767519eb5a822c4848e531a53c0fd054fae934
Stream names within Asterisk can have meaning so when an externally
initiated renegotiation occurs we need to preserve the name of
the stream if it already exists.
Change-Id: I29f50d0cc7f3238287d6d647777e76e1bdf8c596
t38_reinvite_response_cb can get called by res_pjsip_session's
session_inv_on_tsx_state_changed in situations where session->channel
is NULL. If it is, the ast_log warning segfaults because it tries
to get the channel name from a NULL channel.
* Check session->channel and print "unknown channel" when it's NULL.
ASTERISK-27236
Reported by: Ross Beer
Change-Id: I4326e288d36327f6c79ab52226d54905cdc87dc7