- useless return at the end of a function
- mixed tabs & spaces for indentation
- over 80 characters for the comment
- line > 80 characters due to access technology conversion. Replaced
with a direct assignment.
drivers/ubloxmodem/netmon.c: In function ‘req_cb_data_unref’:
drivers/ubloxmodem/netmon.c:131:10: error: ‘return’ with a value, in
function returning void [-Werror]
return NULL;
This adds a netmon driver for ublox. The driver support both +COPS and
+CESQ commands to return the previously added ofono netmon types:
RSCP: Received Signal Code Power
ECN0: Received Energy Ratio
RSRQ: Reference Signal Received Quality
RSRP: Reference Signal Received Power
Current revision makes the driver use ref countig when chaining multiple
AT commands.
The U-Blox documentation specifies the following:
* get interface ip and dns from +CGDCONTRDP
* get gw ip and netmask from +UIPADDR
However, different firmware versions have different befaviour:
* On newer firmware, +UIPADDR returns error. But it's possible to configure
gateway ip == ipterface ip (read from CGDCONTRDP).
* On older firmware, we can actually use the commands specified in the
docs.
This patch runs +CGDCONTRDP, configures everything and then tries to run
+UIPADDR. In that works, reconfigures gw ip and netmask.
Adds U-Blox Toby L2 driver for setting the default APN via the
+UCGDFLT command. Currently only IPv4 is supported. APN is
not stored to modem's non-volatile memory. oFono will manage this
default APN via it's config storage.
When receiving an empty default APN, the value is reset.
For now the driver works only with bridged mode for 2G/3G.
Once it activates the context it reads the ip, netmask,
gw, dns and sets them in the context settings.