In SimManager, the Retries property isn't used for gemalto modems.
The at command AT^SPIC is used to get the remaining retries left
for the current required password type.
This commit enable the use of the driver in the gemalto plugin
The nokia-gpio plugin should not try to create symlinks to relevant gpio
pins under /dev/cmt, since the location it is looking is no longer
correct on newer kernels and it might change again in the future. This
patch removes code from nokia-gpio that tries to create a symlink.
Users will now need to symlink the modem gpios to /dev/cmt themselves.
On the 4.13 kernel, this can be done by, for example, adding a udev rule
to:
# ln -sf /sys/bus/hsi/devices/n900-modem /dev/cmt
The HUP results in errors in gatio which will deref parts
of the AT channel. This makes it impossible to recover and
send further AT commands after the HUP.
This is needed to find out the maximum fragment size that this device
supports. The minimum length specified in the spec is 64, however 512
bytes is recommended.
We also attempt to parse how many simultaneous commands can be
outstanding at a given time. In theory MBIM supports multiple
outstanding commands through the use of transaction-id matching, but it
seems some devices only support a single outstanding command at a time.
This patch fixes up some fallout from the merging of the udev and udevng
modules.
i) The 'serial' modems in question are not necessarily serial modems at
all; for example, the N900 ISI modems appear as network devices and don't
have a devnode. This patch relaxes the requirement that a devnode exist.
ii) The modem driver was being set to 'legacy', which is a remnant of
an earlier approach to merging these modules. The driver needs to be
properly set to the value of the OFONO_DRIVER property in order for the
setup function to be found.
iii) The serial modem's private data was being added to the modem
structure incorrectly...
In particular point iii) above shows that there is essentially nobody
using these devices which makes modifications in this area tricky.
Gemalto modems have hardware related commands, allowing to monitor voltage
and temperature. These parameters will be accessible on DBus interface:
org.ofono.HardwareMonitor.
- Create the DBus method table with one entry: GetStatistics. This method
would return temperature and voltage values.
- Create a dedicated structure to handle the DBus methods.
- Create enable/disable functions to handle DBus interface registration.
Denis Kenzior
James Prestwood
Gabriel Lucas
Ankit Navik
Clayton Craft
Richard Röjfors
Jonas Bonn
Joey Hewitt
Alexander Couzens
Marcel Holtmann
Vincent Cesson
Luiz Augusto von Dentz