The sim atom is now created with the GEMALTO vendor instead of
CINTERION. This is because GEMALTO has superceeded CINTERION and the
gemalto plugin will be updated to handle (legacy) modems from cinterion
as well as current gemalto devices.
In some case linux report 'driver' as valid yet vid and pid as NULL.
Adding NULL check to prevent seg fault.
Log:
ofonod[23829]: plugins/udevng.c:udev_start()
ofonod[23829]: plugins/udevng.c:enumerate_devices()
ofonod[23829]: plugins/udevng.c:check_usb_device() hub [1d6b:0002]
ofonod[23829]: plugins/udevng.c:check_usb_device() usb [1d6b:0002]
ofonod[23829]: plugins/udevng.c:check_usb_device() usbhid [03f0:034a]
ofonod[23829]: plugins/udevng.c:check_usb_device() usbhid [03f0:034a]
ofonod[23829]: plugins/udevng.c:check_usb_device() usb [1d6b:0002]
ofonod[23829]: plugins/udevng.c:check_usb_device() cdc_acm [(null):(null)]
ofonod[23829]: Aborting (signal 11) [./src/ofonod]
Since the merge of udev.c into udevng.c all cleanup function must handle
both usb devices and serial devices. Add this distinction to
check_remove(), so that is doesn't try to iterate the .serial member as
if it were a .devices list.
The return value from ofono_modem_register was not being checked. If this fails
the modem object is not setup and causes a crash. This was specifically seen
when using the mbim driver without having configured with mbim support.
Now the modem object gets destroyed properly if the modem registration fails.
Add support for the SIM7100E modem. We add a new "sim7100" plugin
because there's no other AT-based modem that has support for both GPRS
and voice calls.
This atom needs to be created in post_sim so that the APN can be
written to the default profile before the modem attempts to use the
setting to connect to the network.
In SimManager, the Retries property isn't used for gemalto modems.
The at command AT^SPIC is used to get the remaining retries left
for the current required password type.
This commit enable the use of the driver in the gemalto plugin
The nokia-gpio plugin should not try to create symlinks to relevant gpio
pins under /dev/cmt, since the location it is looking is no longer
correct on newer kernels and it might change again in the future. This
patch removes code from nokia-gpio that tries to create a symlink.
Users will now need to symlink the modem gpios to /dev/cmt themselves.
On the 4.13 kernel, this can be done by, for example, adding a udev rule
to:
# ln -sf /sys/bus/hsi/devices/n900-modem /dev/cmt
The HUP results in errors in gatio which will deref parts
of the AT channel. This makes it impossible to recover and
send further AT commands after the HUP.