MXS specific devices have some common infrastructure in the kernel
known as STMP devices. We have the same in barebox, but with a
mxs_ prefix instead of a stmp_ prefix. As some STMP devices are
also found on i.MX6 move the common infrastructure out of MXS
specific files and use the stmp_ prefix.
This is done in preparation for i.MX6 NAND support.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The boot source for the i.MX23 is configured via a few GPIOs, which are later
be used for different purposes (like LCD data for example). The SoC internal
ROM reads these GPIOs and uses the selected boot source.
For various reasons the boot source is also of interest when Barebox is running.
This detection approach reads again the GPIOs. It switches temporarily the pins
to act as GPIOs and input, reads their settings, and switches back to their
previous functions.
Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The missing 'break' statement lets look an i.MX23 like an i.MX28.
Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
For now only the v1.2 i.MX28 silicon is supported. The actual information is
read from a magic address within the internal SRAM.
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The FSF address has changed in the past. Instead of updating it
each time the address changes, just drop it completely treewide.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
When the i.MX28 boots from USB, the ROM code sets this bit. When
after a reset the ROM code detects that this bit is set it will
boot from USB again. This means that if we boot once from USB the
chip will continue to boot from USB until the next power cycle.
To prevent this (and boot from the configured bootsource instead)
clear this bit here. This bit is not documented in the datasheets,
it was figured out the hard way. Whether this is the same on i.MX23
is currently not known.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
We never supported the sigmatel stm chips and probably
never will. So do the first step and rename the architecture
to mxs just like in the kernel.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>