Adapt phylib from linux
switch all the driver to it
reimplement mii bus
This will allow to have
- phy drivers
- to only connect the phy at then opening of the device
- if the phy is not ready or not up fail on open
Same behaviour as in linux and will allow to share code and simplify porting.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Some phys need board specific fixups. To be able to do this
from board code add mii_open/mii_close functions so that the
board can use the regular mii_read/mii_write functions.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Currently, we can only print the phy_status. Factor out the routine to
get the status, so we can query it from fec drivers and configure
accordingly. Needed because mx28 needs a special bit set for 10Mbit.
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
this rework is done in order to add a phylib and allow to have phy driver support
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Jean-Christophe PLAGNIOL-VILLARD
Johannes Stezenbach
Sascha Hauer
Wolfram Sang