* this compile option actually turns on a command, so name it
accordingly
* also move the Kconfig definition into commands/Kconfig, thus
placing getopt into the "Network commands" section
* while at it, improve Kconfig documention
Signed-off-by: Holger Schurig <holgerschurig@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
* this compile option actually turns on a command, so name it
accordingly
* also move the Kconfig definition into commands/Kconfig, thus
placing getopt into the "Network commands" section
* while at it, improve Kconfig documention
Signed-off-by: Holger Schurig <holgerschurig@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
* this compile option actually turns on a command, so name it
accordingly
* also move the Kconfig definition into commands/Kconfig, thus
placing getopt into the "Shell scripting commands" section
* while at it, improve Kconfig documention
Signed-off-by: Holger Schurig <holgerschurig@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
* CMD_MEMORY was defined both in common/Kconfig and commands/Kconfig
* that symbol turned not a command on, but just the compilation of
commands/mem.c, so rename it accordingly
Signed-off-by: Holger Schurig <holgerschurig@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
With CONFIG_PARTITION_NEED_MTD enabled we use mtd rather than devfs
directly to create partitions on mtd devices. Since:
| commit b32cd8df87
| Author: Sascha Hauer <s.hauer@pengutronix.de>
| Date: Wed Apr 9 15:49:32 2014 +0200
|
| mtd: nand: bb: use mtd api directly
|
| The devfs layer just adds an addition indirection between mtd
| and the bb devices with no purpose. Drop it.
|
| Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The bad block aware device creation doesn't work if this option
is disabled. With this we remove CONFIG_PARTITION_NEED_MTD and always
use mtd partitions on mtd devices.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Adapt phylib from linux
switch all the driver to it
reimplement mii bus
This will allow to have
- phy drivers
- to only connect the phy at then opening of the device
- if the phy is not ready or not up fail on open
Same behaviour as in linux and will allow to share code and simplify porting.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Supported devices:
- nand
- ethernet
- mmc0, mmc1 (on stk5v3 development board)
- led (on stk5v3 development board)
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>