The i.MX23 v2 architecture patch series was sligthly modified to easify
the i.MX28 architecture addition later on. So, we need now an index to
query the SSP clock frequency.
Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Due to a wrong rounding while calculating the clock divider the requested clock
of 25 MHz resulted into a 48 MHz clock. With this patch a clock frequency
below or equal the requested one will be set.
By using 'div' and 'rate' as vars, its also easier to check against the data
sheet.
Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This card is working since 'mci: handle SD cards < 2.0 correctly'
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Tested-by: Jürgen Beisert <jbe@pengutronix.de>
Most SD controllers need some kind of alignment for writing
blocks. Instead of coding this in every driver, align write
blocks to a 4 byte alignment in the mci layer. For DMA
accesses we may need bigger alignment, but let's solve this
problem when we have it.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
With SD cards older than 2.0 the sd_send_if_cond() fails. Do
not assume it's an MMC card in this case. Instead, assume
it's a MMC card if sd_send_op_cond() fails.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This adds a driver for the esdhc controller found on Freescale
i.MX25/35/51 SoCs.
This code is based on the U-Boot driver.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Adding MCI card support for S3C2440 CPUs. This is for reference only, as there
is currently no user in the barebox tree. Maybe one with access to the A9M2440
development kit can check it on his/her system.
Checked here with my own S3C2440 based system which is not in the barebox tree.
Signed-off-by: Juergen Beisert <juergen@kreuzholzen.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Adding MCI card support for STM378x/i.MX23 CPUs. This is for reference only,
as this architecture is currently not part of barebox (but will coming soon).
Its tested on the i.MX23 based ChumbyOne.
Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This adds the basic framework to handle MCI cards in barebox.
Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Juergen Beisert
Eric Bénard
Sascha Hauer
Juergen Beisert