As the place for the atags now is determined automatically the call
from the boards can be removed.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
- USB1 is host (tested with a mass storage)
- USB0 is device (quickly tested with DFU)
Signed-off-by: Eric Bénard <eric@eukrea.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
With multiboard support the compiletime generated BOARDINFO string
gets more and more meaningless. This removes it from Kconfig and
replaces it with a variable that can be set at boardlevel.
Also many boards have a standard setting for the hostname in the
environment. This patch also moves the standard to C code by calling
barebox_set_hostname().
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The convenience wrapper also contains the bch resources to
get rid of the hardcoded base in the driver in the next step.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Some boards have board specific special clock setups. These are now
done in the SoC specific clock drivers.
It is assumed that most board specific clock setup is done based on
copy/paste from U-Boot. The generalized clock setup differs from
some boards:
- ioclk are adjusted to 480MHz
- ssp clocks are adjusted to 96MHz
- enet out clock is enabled
Some boards adjusted the ioclk to 320MHz and the ssp clock to 160MHz.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Use MMC_CAP_ names instead of MMC_MODE_. This makes it more
clear that these are capabilities of host/card and do not refer
to the current mode. These are in line with the Linux Kernel
except for MMC_CAP_MMC_HIGHSPEED_52MHZ which could be fixed
later.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
While flash layout may be custom, at least the nand0-device is good to
have.
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This adds the device id mechanism to the i.MX fec driver and
uses it to determine the fec version. Also adds devicetree
probing support.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
For some reason, the mxs-boards missed some length parameters when adding
devices. This made reading from ocotp crash in the current version.
Provide missing lengths, use a consistent format and fix the length for
the LCDIF.
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This patch adds basic support for the mx28-evk board. Debug UART, MMC and FEC
have been successfully used.
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Sascha Hauer
Eric Bénard
Michael Grzeschik
Wolfram Sang
Allan Heldgaard