so we can use dynamic number id with specific devname
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Activate the netconsole in the set_active callback. Add proper
checks there for port and ip address, print an error when the network
hasn't been configured and finally print when the netconsole has
been enabled successfully. This makes using of the netconsole easier.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The doxygen documentation is long outdated. Remove it. It will
be replaced with sphinx based documentation later.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
When no connection is opened we should not call into
the networking stack. Otherwise it can happen that we
delay further execution until the network stack detected
a link (or timed out bringing the link up).
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
None of the driver make the difference between STDOUT and STDERR.
So we just need to check if putc or getc are filled in the console_device
save 32 bytes on versatilepb
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The FSF address has changed in the past. Instead of updating it
each time the address changes, just drop it completely treewide.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This is not yet used, but with this the different network
commands can get rid of their global data.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Jean-Christophe PLAGNIOL-VILLARD
Sascha Hauer