* this compile option actually turns on a command, so name it
accordingly
* also move the Kconfig definition into commands/Kconfig, thus
placing getopt into the "Network commands" section
* while at it, improve Kconfig documention
Signed-off-by: Holger Schurig <holgerschurig@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Add an environment partition and support commands so that the system
configuration can be permanent.
Signed-off-by: Renaud Barbier <renaud.barbier@ge.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Enable memtest, MMU and iomem support on the P2020RDB and DA923RC.
Signed-off-by: Renaud Barbier <renaud.barbier@ge.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Support for both i2c busses on the p2020rdb board is added and the
configuration file is updated to add the I2C driver and commands.
Signed-off-by: Renaud Barbier <renaud.barbier@ge.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Minimal support of the Ethernet interface on the P2020RDB board. Only
the eTSEC3 interface is supported.
Signed-off-by: Renaud Barbier <renaud.barbier@ge.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This is limited board support for the Freescale P2020RDB in single CPU
mode. The DDR is configured for a memory bus running at 667Mhz.
The system boots from NOR flash and provides the console at 115200
bauds, no other drivers are included.
Finally, the PPC Kconfig and make file make the building of
the P2020RDB platform firmware possible.
Signed-off-by: Renaud Barbier <renaud.barbier@ge.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Holger Schurig
Renaud Barbier
Sascha Hauer