Add and use meaningful macro names for OMAP4 GPIO addresses, and add a
comment to explain the 0x100 offset for OMAP4.
Signed-off-by: Robert P. J. Day <rpjday@crashcourse.ca>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
- increased the region size for OMAP3, as it was not correct
- decrease region size for OMAP4 to prevent overlapping.
Signed-off-by: Teresa Gámez <t.gamez@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
As the gpio functions are not available at this point, set the gpio manually.
Signed-off-by: Teresa Gámez <t.gamez@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
based on: [U-Boot] [PATCH v 4/5] omap4: support TPS programming
TPS62361 is the new power supply used in OMAP4460 that
supplies vdd_mpu.
VCORE1 from Phoenix supplies vdd_core and VCORE2 supplies
vdd_iva. VCORE3 is not used in OMAP4460.
Signed-off-by: F. Gasnier fabrice.gasnier@cenosys.com
Signed-off-by: Jan Weitzel <j.weitzel@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Without yet adding in the underlying code, extend the revision
checking code to return additional values for PandaBoard ES boards.
Much of the code was taken close to verbatim from U-Boot.
compile tested, and confirmed that this code behaves identically to
the original panda configure and build for the three pandas i have:
* Rev A2 (boots)
* Rev EA3 (boots)
* Rev B1 ES (no output)
so while there's still work to be done, this at least represents the
necessary infrastructure to start *recognizing* panda ES boards.
Signed-off-by: Robert P. J. Day <rpjday@crashcourse.ca>
Tested-by: Anand Gadiyar <gadiyar@ti.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Add a OMAP4 specific GMPC nand config for pcm049 and phyCARD-A-XL2 to increase
performance. Also add the possiblility to pass a board GPMC nand config.
Signed-off-by: Teresa Gámez <t.gamez@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
To allow for some generic io accessors introduce io.h and use
this instead of asm/io.h throughout the tree.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
If OMAP4 fall back to MMC1 boot in bootmode 0x39 (NAND,USB,UART,MMC1)
NAND and MMC bit in TRACING_VECTOR3 are set. With changed order it will
detect boot from MMC.
Signed-off-by: Jan Weitzel <j.weitzel@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Add some common xload helper functions to determine the boot source
on omap3/4 and to load images from mmc and nand.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Robert P. J. Day
Vicente
Teresa Gámez
Jan Weitzel
Sascha Hauer