u-boot/arch/arm/mach-omap2/lowlevel_init.S

91 lines
1.8 KiB
ArmAsm
Raw Normal View History

/*
* Board specific setup info
*
* (C) Copyright 2010
* Texas Instruments, <www.ti.com>
*
* Author :
* Aneesh V <aneesh@ti.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <config.h>
#include <asm/arch/omap.h>
#include <asm/omap_common.h>
#include <asm/arch/spl.h>
#include <linux/linkage.h>
.arch_extension sec
#ifdef CONFIG_SPL
ENTRY(save_boot_params)
ldr r1, =OMAP_SRAM_SCRATCH_BOOT_PARAMS
str r0, [r1]
b save_boot_params_ret
ENDPROC(save_boot_params)
#if !defined(CONFIG_TI_SECURE_DEVICE) && defined(CONFIG_ARMV7_LPAE)
ENTRY(switch_to_hypervisor)
/*
* Switch to hypervisor mode
*/
adr r0, save_sp
str sp, [r0]
adr r1, restore_from_hyp
ldr r0, =0x102
b omap_smc1
restore_from_hyp:
adr r0, save_sp
ldr sp, [r0]
MRC p15, 4, R0, c1, c0, 0
ldr r1, =0X1004 @Set cache enable bits for hypervisor mode
orr r0, r0, r1
MCR p15, 4, R0, c1, c0, 0
b switch_to_hypervisor_ret
save_sp:
.word 0x0
ENDPROC(switch_to_hypervisor)
#endif
#endif
ENTRY(omap_smc1)
push {r4-r12, lr} @ save registers - ROM code may pollute
@ our registers
mov r12, r0 @ Service
mov r0, r1 @ Argument
dsb
dmb
smc 0 @ SMC #0 to enter monitor mode
@ call ROM Code API for the service requested
pop {r4-r12, pc}
ENDPROC(omap_smc1)
ENTRY(omap_smc_sec)
push {r4-r12, lr} @ save registers - ROM code may pollute
@ our registers
mov r6, #0xFF @ Indicate new Task call
mov r12, #0x00 @ Secure Service ID in R12
dsb
dmb
smc 0 @ SMC #0 to enter monitor mode
b omap_smc_sec_end @ exit at end of the service execution
nop
@ In case of IRQ happening in Secure, then ARM will branch here.
@ At that moment, IRQ will be pending and ARM will jump to Non Secure
@ IRQ handler
mov r12, #0xFE
dsb
dmb
smc 0 @ SMC #0 to enter monitor mode
omap_smc_sec_end:
pop {r4-r12, pc}
ENDPROC(omap_smc_sec)