Commit graph

14 commits

Author SHA1 Message Date
Vignesh R
5746b0df9c gpio: Add driver for TI PCF8575 I2C GPIO expander
TI's PCF8575 is a 16-bit I2C GPIO expander.The device features a
16-bit quasi-bidirectional I/O ports. Each quasi-bidirectional I/O can
be used as an input or output without the use of a data-direction
control signal. The I/Os should be high before being used as inputs.
Read the device documentation for more details[1].

This driver is based on pcf857x driver available in Linux v4.7 kernel.
It supports basic reading and writing of gpio pins.

[1] http://www.ti.com/lit/ds/symlink/pcf8575.pdf

Signed-off-by: Vignesh R <vigneshr@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Mugunthan V N <mugunthanvnm@ti.com>
2016-08-08 13:32:53 -04:00
Bin Meng
2600ba6de0 x86: Update x86-pinctrl driver device-tree-bindings doc
This updates the device-tree-bindings doc for x86-pinctrl driver:

 - clarify "gpio-offset" is required only when "mode-gpio" is set
 - correct property name "pull-strength"
 - use tab instead of space at several places

Signed-off-by: Bin Meng <bmeng.cn@gmail.com>
Reviewed-by: Stefan Roese <sr@denx.de>
Reviewed-by: Simon Glass <sjg@chromium.org>
2016-06-12 12:19:35 +08:00
Stephen Warren
074a1fdd27 gpio: add Tegra186 GPIO driver
Tegra186's GPIO controller register layout is significantly different from
previous chips, so add a new driver for it. In fact, there are two
different GPIO controllers in Tegra186 that share a similar register
layout, but very different port mapping. This driver covers both.

The DT binding is already present in the Linux kernel (in linux-next via
the Tegra tree so far).

Signed-off-by: Stephen Warren <swarren@nvidia.com>
Reviewed-by: Simon Glass <sjg@chromium.org> # v1
Signed-off-by: Tom Warren <twarren@nvidia.com>
2016-05-31 09:54:24 -07:00
Mateusz Kulikowski
120800df72 gpio: Add support for Qualcomm PM8916 gpios
This driver supports GPIOs present on PM8916 PMIC.
There are 2 device drivers inside:
- GPIO driver (4 "generic" GPIOs)
- Keypad driver that presents itself as GPIO with 2 inputs (power and reset)

Signed-off-by: Mateusz Kulikowski <mateusz.kulikowski@gmail.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Tested-by: Simon Glass <sjg@chromium.org>
2016-04-01 17:18:13 -04:00
Mateusz Kulikowski
81a87e1894 gpio: Add support for Qualcomm gpio controller
Add support for gpio controllers on Qualcomm Snapdragon devices.
This devices are usually called Top Level Mode Multiplexing in
Qualcomm documentation.

Signed-off-by: Mateusz Kulikowski <mateusz.kulikowski@gmail.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Tested-by: Simon Glass <sjg@chromium.org>
2016-04-01 17:18:07 -04:00
Simon Glass
b24f5c4f27 x86: broadwell: Add a pinctrl driver
GPIO pins need to be set up on start-up. Add a driver to provide this,
configured from the device tree.

The binding is slightly different from the existing ICH6 binding, since that
is quite verbose. The new binding should be just as extensible.

Signed-off-by: Simon Glass <sjg@chromium.org>
Acked-by: Bin Meng <bmeng.cn@gmail.com>
2016-03-17 10:27:26 +08:00
Simon Glass
c13dcb3dc7 x86: dts: Update the pinctrl binding a little
Make a few minor updates to make the meaning clearer.

Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
2016-03-17 10:27:25 +08:00
Simon Glass
7ac99be6e2 x86: Add an ICH6 pin configuration driver
Add a driver which sets up the pin configuration on x86 devices with an ICH6
(or later) Platform Controller Hub.

The driver is not in the pinctrl uclass due to some oddities of the way x86
devices work:

- The GPIO controller is not present in I/O space until it is set up
- This is done by writing a register in the PCH
- The PCH has a driver which itself uses PCI, another driver
- The pinctrl uclass requires that a pinctrl device be available before any
other device can be probed

It would be possible to work around the limitations by:
- Hard-coding the GPIO address rather than reading it from the PCH
- Using special x86 PCI access to set the GPIO address in the PCH

However it is not clear that this is better, since the pin configuration
driver does not actually provide normal pin configuration services - it
simply sets up all the pins statically when probed. While this remains the
case, it seems better to use a syscon uclass instead. This can be probed
whenever it is needed, without any limitations.

Also add an 'invert' property to support inverting the input.

Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
2016-03-17 10:27:25 +08:00
Thomas Chou
88d5ecf4b9 nios2 : convert altera_pio to driver model
Convert altera_pio to driver model.

Signed-off-by: Thomas Chou <thomas@wytron.com.tw>
Acked-by: Chin Liang See <clsee@altera.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
2015-10-23 07:37:03 +08:00
Gabriel Huau
5318f18d2c x86: gpio: add pinctrl support from the device tree
Every pin can be configured now from the device tree. A dt-bindings
has been added to describe the different property available.

Change-Id: I1668886062655f83700d0e7bbbe3ad09b19ee975
Signed-off-by: Gabriel Huau <contact@huau-gabriel.fr>
Acked-by: Simon Glass <sjg@chromium.org>
2015-06-04 03:32:08 -06:00
Masahiro Yamada
ba25779384 Documentation: gpio: fix bindings document
[ imported from Linux Kernel, commit 74981fb81d83 ]
Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Simon Glass <sjg@chromium.org>
2015-02-19 06:19:19 -07:00
Simon Glass
5cfc662c49 dm: tegra: Bring in GPIO device tree binding
At present the tegra GPIO driver does not fully support the existing device
tree binding, but add the binding file to cover the existing partial support.

Signed-off-by: Simon Glass <sjg@chromium.org>
2015-01-29 17:09:50 -07:00
Simon Glass
35ea1bfde3 dm: exynos: Bring in GPIO device tree binding
At present the exynos GPIO driver does not fully support the existing device
tree binding, but add the binding file to cover the existing partial support.

Signed-off-by: Simon Glass <sjg@chromium.org>
2015-01-29 17:09:50 -07:00
Simon Glass
9f4cd0200c dm: gpio: Bring in GPIO device tree binding
Add the binding file that we are about to support.

Signed-off-by: Simon Glass <sjg@chromium.org>
2015-01-29 17:09:50 -07:00