u-boot/board/bachmann/ot1200
Christian Gmeiner 130e6c8cbd ot1200: setup i2c bus 1 in setup_iomux_i2c()
On this bus there is a EEPROM containing EDID and ddr3
calibration information.

Signed-off-by: Christian Gmeiner <christian.gmeiner@gmail.com>
2015-06-08 08:48:32 +02:00
..
Kconfig kconfig: arm: introduce symbol for ARM CPUs 2014-10-29 09:02:09 -04:00
MAINTAINERS imx6: add Bachmann OT1200 board 2014-10-06 17:24:28 +02:00
Makefile ot1200: add basic SPL support 2015-01-22 11:03:19 +01:00
mx6q_4x_mt41j128.cfg ot1200: move ccgr and gpr init to c functions 2015-01-22 11:03:19 +01:00
ot1200.c ot1200: setup i2c bus 1 in setup_iomux_i2c() 2015-06-08 08:48:32 +02:00
ot1200_spl.c ot1200: add basic SPL support 2015-01-22 11:03:19 +01:00
README imx6: add Bachmann OT1200 board 2014-10-06 17:24:28 +02:00

U-Boot for the Bachmann electronic GmbH OT1200 devices

There are two different versions of the base board, which differ
in the way ethernet is done. The variant detection is done during
runtime based on the address of the found phy.

- "mr" variant
FEC is connected directly to an ethernet switch (KSZ8895). The ethernet
port is always up and auto-negotiation is not possible.

- normal variant
FEC is connected to a normal phy and auto-negotiation is possible.


The variant name is part of the dtb file name loaded by u-boot. This
make is possible to boot the linux kernel and make use variant specific
devicetree (fixed-phy link).

In order to support different display resoltuions/sizes the OT1200 devices
are making use of EDID data stored in an i2c EEPROM.