Add speedup_set_online.
Add a polling mechanism since most speedup dongles failed in couple of
AT commands following the CFUN=1 when they are offline.
Cleanup online polling in case modem is removed during online process.
A call that moves from the dialing to active state before the +CLCC response
will not properly be added as a voicecall. This is because the dialing callback
was using simplified handling and only looked for calls in the dialing or
alerting state.
AT sequence that exhibited the failure (AG device was an iPhone accessing
visual voicemail):
> +CIND: ("service",(0-1)),("call",(0-1)),("callsetup",(0-3)),
("battchg",(0-5)),("signal",(0-5)),("roam",(0-1)),("callheld",(0-2))
...
> +CIEV: 3,2
< AT+CLCC
> +CIEV: 2,1
> +CIEV: 3,0
> +CLCC: 1,0,0,0,0,"**21153**",129,"Voicemail"
Even though service watches accepted a "destroy" callback, they were
being ignored. This fix properly pass them along so they are called when
the watch is removed.
Voice output serial port is enabled on some Huawei models (e.g. E169)
without problems, but for example on E173u-2 it is never enabled
during an incoming call. There might also be other Huawei models
having the same issue.
I traced the issue down to "^DDSETEX" AT command, which is used
to notify the device to start streaming audio. It seems that Ofono
sends this command too early on incoming calls. The command should
always be sent *after* the dial "D" or answer "A" command. The patch
fixes this behavior and afterwards voice will also work on E173u-2.
Indicators should not be updated if:
- multiple separate calls are active at same time
- a conf call and a call are active at same time
- multiple separate calls are held at same time
- a conf call and a call are held at same time
- a conf call has call in active and held state