Add a function to take the usbphy1 through its initialization procedure.
The imx6_usb_phy1_disable_oc function is needed at least on the sabrelite,
as the power design is faulty. The state on other imx6 boards is unknown,
therefore it is an extra function call at the moment.
Signed-off-by: Steffen Trumtrar <s.trumtrar@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
With pbl support enabled most boards need a pbl-y for their lowlevel
stuff.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Reimplement the code from lowlevel.S in C. It is run
from SDRAM anyway, so we can safely do this initialization
in a regular barebox environment instead in Assembly.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
- move code which can be shared between i.MX53 and i.MX51
to a common file
- rename mx53_init_lowlevel to imx53_init_lowlevel
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The i.MX Processors support two different boot modes, the internal
boot mode and the external boot mode. Traditionally the external
NAND boot mode is handled in drivers/mtd/nand and the internal
boot mode is handled in arch/arm/mach-imx. This patch consolidates
the handling of both boot modes in arch/arm/mach-imx so that
the user does not have to look in the mtd kconfig section for
booting from NAND. Also, selecting between internal and external
boot mode now is a clear choice.
The external NAND boot mode has been independent of the mtd nand
driver, but as the code was contained in the NAND driver it was
not possible to support booting from NAND without a mtd nand driver.
This is changed with this patch.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Saves the boot source into an environment variable so env scripts
can more easily use boot source information.
Note only tested on imx35. I haven't added support for any other variants
because I'm not familiar with them. (And can't test them anyway).
Signed-off-by: Marc Reilly <marc@cpdesign.com.au>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This driver provides an interface for programming and sensing the IIM fusebox
which is present on some i.MX chips.
Since the IIM io addresses of the controlling registers and each fuse bank are
are not contiguous the driver implementation uses two drivers, imx_iim, and
imx_iim_bank. The imx_iim is the "parent" driver for a device holding the
map_base address of the control registers. The imx_iim_bank driver is for
child devices holding the map_base of each fuse bank. The platform code then,
instantiate one imx_iim_bank device per fuse bank.
Fuses blow is a dangerous operation. Thus, the fuses blow functionality can be
disabled independently at configuration time. On run time this functionality
must be enabled explicitly by setting the permanent_write_enable parameter.
Signed-off-by: Baruch Siach <baruch@tkos.co.il>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Sascha Hauer
Steffen Trumtrar
Juergen Beisert
Marc Kleine-Budde
Marc Reilly
Baruch Siach
Ivo Clarysse
Juergen Beisert