FUSEs (OTP registers) can be written via /dev/imx-ocotp character device.
For example, writing MAC 12:34:56:78:9A:BC can be performed as
> mw -l -d /dev/imx-ocotp 0x8c 0x00001234
> mw -l -d /dev/imx-ocotp 0x88 0x56789ABC
and reading as
> md -l -s /dev/imx-ocotp 0x88+8
00000088: 56789ABC 00001234
, where 0x88 (0x22*4) and 0x8C (0x23*4) are offsets of MAC OTP registers.
Notice: FUSEs are PROM, so "0" (unprogrammed) bits
can be replaced with "1" (but not vice versa) only once.
Also, for MAC there are convinient parameters:
> ocotp0.permanent_write_enable=1
> ocotp0.mac_addr=12:34:56:78:9A:BC
imx_ocotp 21bc000.ocotp: reloading shadow registers...
imx_ocotp 21bc000.ocotp: reloading shadow registers...
> echo $ocotp0.mac_addr
12:34:56:78:9A:BC
Signed-off-by: Uladzimir Bely <u.bely@sam-solutions.net>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
RX DMA Head Descriptor Pointer can get 0 when there is a lot of traffic,
which results in a timeout error. A good way to provoke this error is by
sending lots of ARP requests. This patch makes sure that the RX DMA Head
Descriptor Pointer is set.
The origin driver, from which this is derived, already contains this fix.
Signed-off-by: Christoph Fritz <chf.fritz@googlemail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
If there's packet loss and the remote server needs to retransmit,
there is falsely no timeframe left because TIMEOUT (server wait time)
and TFTP_TIMEOUT (abort timer) are the same.
This patch increases TFTP_TIMEOUT.
See RFC2349 for more info: http://tools.ietf.org/html/rfc2349
Signed-off-by: Christoph Fritz <chf.fritz@googlemail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Move the imx6-reg.h include to the imx6-mmdc header.
Signed-off-by: Christian Hemp <c.hemp@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Add support for Phytec phyCARD-i.MX6.
- 1GB RAM on two banks
- 1GB RAM on one bank
- 2GB RAM on two banks
Signed-off-by: Christian Hemp <c.hemp@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This patch corrects exporting unsigned 64-bit environment variables.
I had left out a signed off line before.
Signed-off-by: Michael Burkey <mdburkey at gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
this board is produced by Embest/Element 14 and is based on i.MX6 Solo
The following features are tested :
- UART2 (console)
- eMMC
- SDCard
- uSDCard
- Ethernet
- USB Host (through 4 ports hub)
- I2C 1/2/3
- 2 LEDs
Boot on eMMC and through USB loader are tested.
For more informations on this board : http://www.riotboard.org/
Signed-off-by: Eric Bénard <eric@eukrea.com>
Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Clock gates having the CLK_GATE_HIWORD_MASK flag set use the upper 16
bits of the register as a "write enable" mask for the value in the
lower 16 bits.
Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
To avoid code duplication and make easier to introduce new flags.
Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This adds a clk_gate_flags argument to clock gate creation functions
to allow the introduction of new clock gate modifiers.
Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This patch adds a basic support for the ARM-based Rockchip SoCs of the
RK3xxx family.
Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This patch adds support for the Synopsys 10/100 Mbps Ethernet MAC used
on some ARC devices and on Rockchip SoCs.
Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
GENERIC_GPIO is selected automatically by GPIOLIB
Signed-off-by: Alexander Shiyan <shc_work@mail.ru>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
We need list_for_each_entry_safe in dev_remove_bb_dev since the
list entries are removed during iteration over the list.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Reported-by: Alexander Aring <alex.aring@gmail.com>
Provide minimal regulator support. Only supported operations are enabling
and disabling regulators. Association of devices with their regulators is
limited to devicetree only. If regulator support is disabled the API expands
to static inline stubs so consumers can still use the API.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
when $target is a path relative to $objtree the script fails.
This is because we cd to $basedir and then copy to $tempdir which
then is no longer valid. Fix this by converting $tempdir to an
absolute path first.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Tested-by: Christoph Fritz <chf.fritz@googlemail.com>
The pingrp defines never made it upstream, so roll back the changes
and use the individual pin defines for the Efika sb instead.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
barebox used to have its own include/dt-bindings with files copied
from the corresponding kernel files. Use upstream dt-bindings directly
instead.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
To reduce the devicetree files for one board with different memory sizes the
memory size can be read back from i.MX6.
Signed-off-by: Christian Hemp <c.hemp@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
When a mtd device can have bad blocks we want to create a
bb device, so do this automatically. This allows us to
drop bb device creation from the environment.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
This refactors the code so that we get a mtd_add_bb which can
be used to create a bb dev on a mtd_info.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The devfs layer just adds an addition indirection between mtd
and the bb devices with no purpose. Drop it.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
The purpose of envfs_register_partition is to print an error
message when the partition does not exist. Print an error message
from generic code instead and drop this function.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>